Go Bottom

3 POINT HITCH

View my Photos
skipll
Join Date: Feb 2011
Posts: 184 Robbisville NC USA
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2011-04-05          177796


Can someone please tell me the correct procedure for connecting up implements to a 3 point hitch.---Which do ya connect first. The tube assby--- Or the 2 other pins? Is there a link on here---a tutorial perhaps---Have Googled to no avail.
I only do this 4-6 times a year ---most of the time have real Battle doing it.

The disc harrow is a Nightmare to hook up.




Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



3 POINT HITCH

View my Photos
auerbach
Join Date: Sep 2007
Posts: 2168 West of Toronto
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2011-04-05          177797


You're not the only one with this problem. That's why there's so many different quick-attachment devices to make it easier.

A few tractors have a "creeper" gear. The design purpose was for a slow backing into the implement. And some models like the Kioti have telescoping lower arms and I think controls at the rear so you can adjust them to the attachment.

It's best to prepare for attaching when you're detaching. As you take the implement off, rig up a stand or some blocks that will hold it in the attached position. To put it back on, just back up to it and it's all ready.

As for which of the three places to connect first, whatever works the easiest. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



3 POINT HITCH

View my Photos
greg_g
Join Date: Jan 2004
Posts: 1816 Western Kentucky
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2011-04-05          177798


Connect the lower lift arms first, finish with the toplink. Sounds like you could use a set of Pat's Easy Hitches. They pin to your lower lift arms, but are open at the top (like a hook). You back them under the implement lift pins, then just raise up the lift arms to hook up. Then pin the toplink, and you're done.

See link below

//greg// ....


Link:   Easy Hitch

 

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



3 POINT HITCH

View my Photos
kthompson
Join Date: Oct 2005
Posts: 5275 South Carolina
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2011-04-06          177807


Agree with Greg's thoughts. The negative I have seen with with those of Pat's design has been you are moving the load further back (lift capacity and light front end) and pto shafts may need to be longer.

For me connecting the lowest lift pin on the implement and then using the lift itself to slowly life to get the higher pin to line up. Yes, the third arm is the last connect to make and the first to disconnect.

Think Auerback said the next easy hook up begins with proper disconnect...he is so right. Get both tractor and implement level and make sure lift arms will lower below the pin height before you cut loose. No fun to have to lift something to have to connect it. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


   Go Top


Share This







Member Login