crossreference v belts
PETERPETER
Join Date: Nov 2013 Posts: 3 connecticut |
2013-11-24 188381
Hello I own a 1968 MASSEY Ferguson MF10,i can't figure the right size belts to run on machine,the belt that goes from crank pulley to variator is 50"x7/8"x38 degrees,and belt that goes from variator too transmission is 60"x7/8"x38 degrees. I don't think thear the right belt,machine has a lot of slippage when it starts to roll.does any body have the right p/n for thease belts. THANKS A LOT PETERPETER
Reply to | Quote Reply | Add Photo
crossreference v belts
kwschumm
Join Date: Feb 2003 Posts: 5764 NW Oregon Pics |
2013-11-25 188387
You might try these guys:
http://www.yesterdaystractors.com
they don't list the belt on their web site but I would bet they have the one you need if you contact them directly. ....
Reply to | Quote Reply | Add Photo
crossreference v belts
PETERPETER
Join Date: Nov 2013 Posts: 3 connecticut |
2013-11-25 188389
Thank You,kwschumm for your information I will check with them and,post results in messages.
....
Reply to | Quote Reply | Add Photo
crossreference v belts
Art White
Join Date: Jan 2000 Posts: 6898 Waterville New York Pics |
2013-12-05 188409
Those were a bid mower built by AMF at the time. We do often use generic belts on them although I believe they would be 3/8's or 1/2" for the back width. Check your pulley openings width to be sure as to which belt might drop in the best. ....
Reply to | Quote Reply | Add Photo
Go Top
Share This