TN65D New Holland wont start
| jgarner
Join Date: Feb 2011 Posts: 3 Georgia
|
2011-02-21 176933
I have a 2000 New Holland TN65D that wont start. It ran fine 5 days ago. I drained the fuel, replaced the filter and it still wont start. Turns over ok. My Tractor has the Fiat 3 cylinder diesel engine. Any ideas or troubleshooting techniques that I should try?
Reply to |
TN65D New Holland wont start
| auerbach
Join Date: Sep 2007 Posts: 2168 West of Toronto
|
2011-02-21 176936
Did you bleed it properly after the fuel servicing? Does it spin rapidly?
If it's not fuel or battery/starter, I'd look to the fuel injectors or more likely the pump, but first measure the compression if you can. ....
Reply to |
TN65D New Holland wont start
| jgarner
Join Date: Feb 2011 Posts: 3 Georgia
|
2011-02-21 176940
Thank you for your response. I am not sure of the proper bleed procedures. The engine turns over normally. Also, do you know where the fuel pump is located? ....
Reply to |
TN65D New Holland wont start
| treeman
Join Date: Feb 2002 Posts: 251 Wisconsin
|
2011-02-21 176941
On my tc33d, I turn the fuel off, remove sediment bowl, turn fuel on to rid any water, shut fuel off. Install new filter and turn fuel on. Then to bleed the system I follow the fuel line to the pump and find the bleed screw. Open the screw until fuel runs freely, then close. This insures that fuel is to the pump with no air. If you try to start it without bleeding, air will be in the pump and injector lines. Other people will hopefully what to do next. ....
Reply to |
TN65D New Holland wont start
| auerbach
Join Date: Sep 2007 Posts: 2168 West of Toronto
|
2011-02-21 176944
If you don't know how to bleed it, the problem is likely air in the fuel line, by now downstream of the filter. Probably requires bleeding at the pump and at the injectors, for which it would be helpful for you to have a manual. ....
Reply to |

Share This