Go Bottom Go Bottom

John Deere 850 Power steering

View my Photos
gjt1961
Join Date: Aug 2007
Posts: 2 Illinois
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2007-08-07          144416

I have a 1989 John Deere 850 w/loader and power steering. Looking for a replacement power steering assist cylinder. Old one is not repairable and are obsoltete from dealer any suggestions would be greatly appreciated. I have already taken off cylinder and put on drag link to be able to use tractor but with loader it is hard to steer.

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John Deere 850 Power steering

View my Photos
Murf
Join Date: Dec 1999
Posts: 7249 Toronto Area, Ontario, Canada
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2007-08-07          144417

Why is the old one not repairable?

It must be pretty badly mangled to be beyond repair. We've demo'd some pretty good over the years, mostly rock hits to the bucket curl cylinder on a B/H but a few others too, all were fixable, albeit some needed new piston rods.

Any good hydraulic shop should be able to make up a replacement cylinder.

Best of luck. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John Deere 850 Power steering

View my Photos
candoarms
Join Date: Mar 2007
Posts: 1932 North Dakota
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2007-08-07          144418

Gjt1961,

Hydraulic cylinders are fairly generic in nature. You shouldn't have any problem finding a replacement, so long as you make the necessary measurements and properly match the mounting supports.

Measure the overall length of the cylinder when in the closed position.

Measure the length of the cylinder when fully extended.

Find the diameter of the outer tube.

Measure the diameter of the cylinder's shaft.

Make note of the style of the supports on each end of the cylinder, and then measure the bolt holes if there are any.

Once you have these critical measurements, finding a replacement cylinder should be quite easy.

Try Surplus Center. I find 444 matches for keywords "Hydraulic Cylinder"

See link posted below.

Joel

....


Link:   Surplus Center -- Replacement Hydraulic Cylinders

 
Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John Deere 850 Power steering

View my Photos
leejohn
Join Date: May 2007
Posts: 71 Doniphan, Missouri
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2007-08-07          144438

Is your power steering factory installed or is it the add on kit that they had? Lee ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John Deere 850 Power steering

View my Photos
gjt1961
Join Date: Aug 2007
Posts: 2 Illinois
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2007-08-09          144503

It is a factory cylinder. The cylinder housing is broken off on the end were the control valve is mounted and broken the control valve. I have taken it to a machinist there is one piece missing wich he said makes it almost impossible to weld up and machine down to spec not to mention very costly to try if it does not work. I have checked aftermarket companies and there are limited availability due to the fact mine has the control valve made into the endof the cylinder and all the ones I have found so far are longer wich is not a great problem I can relocate the mount end of the cylinder. The later models have the control valve at the bottom of the steering colum. I was hoping to find a used factory one I can rebuild and use. Thanks for all your help. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


  Go Top Go Top

Share This
Share This







Member Login