
Need advice to remove nailed-on metal barn siding
![]() | earthwrks
Join Date: Dec 2003 Posts: 3853 Home Office in Flat Rock, Michigan ![]() ![]() |
2008-07-07 155149
I may be dismanting a three-car garage/pole barn. It has metal siding that is nailed on with the standard rubber-gasketed siding nails. I don't want to damage the siding as it's in great condition. And I have to do this economically and quickly before it gets torn down. I knwo from experience just a claw hammer and a block of wood won't work. There's gotta be some sort pneumatic "slide hammer" out there. If not, hmmmm--- maybe I'll make one!
Reply to |


Need advice to remove nailed-on metal barn siding
![]() | auerbach
Join Date: Sep 2007 Posts: 2168 West of Toronto ![]() ![]() |
2008-07-07 155154
A good nail puller works (with a block to keep it from damaging the siding where it levers against it). Those gaskets don't provide any holding power; they're just a water seal, and make pulling easier because the nail isn't in as far as it could be. Have fun. ....
Reply to |


Need advice to remove nailed-on metal barn siding
![]() | harvey
Join Date: Sep 2000 Posts: 1550 Moravia, NY ![]() ![]() |
2008-07-07 155157
The big boys use a large pair nipper cutter,pliers. They have a rod welded on one handle with a slide weight.
I works just like a slide hammer with a solid bite on nail. I watched these guys only use one slide most of time sometimes 2-3 depending on wood condition. ....
Reply to |


Need advice to remove nailed-on metal barn siding
![]() | Murf
Join Date: Dec 1999 Posts: 7249 Toronto Area, Ontario, Canada ![]() ![]() |
2008-07-08 155168
Yup, Harvey nailed it! (pun intended LOL )
Have a look at the McMaster-Carr site (see link below) and what you are looking for is part # 6094A31 which is item 'G' in the upper row of pictures.
If that won't take them out clean, give up.
Any good hardware place should have something similar, but watch out for the cheap alternatives, they don't have a place for your second hand, just a lever arm that will put a dent in the siding.
Best of luck. ....
Link: McMaster-Carr
 
Reply to |


Need advice to remove nailed-on metal barn siding
![]() | anthonyc12
Join Date: Sep 2013 Posts: 5 USA ![]() |
2013-09-20 188000
carefully grind the heads off
A cordless 4.5" grinder with a spare battery would be nice .. if u have one or could borrow one ....
Reply to |




Share This