Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

AW32 (also known as ISO32) is a very thin hydraulic fluid with a viscosity equivalency of about 10w engine oil. In Chinese tractors operated in cold weather, the thinner the hydraulic fluid the better. I think your JM180 holds about 9 liters

//greg//

Best placement of magnetic heater
Jinma Farmpro Agracat Nortrac
Replies 9 Post by greg_g

<br>
A RIDE DOWN MEMORY LANE WHO REMEMBERS THESE?<br>
King Midget Cars<br>
Whizzer Motor Bikes

MIDGET CARS AND MOTOR BIKES
Just For Fun Off Topic
Replies 6 Post by lbrown59

Grinder Don't worry about the transfer panel you electrician install, I know the panel you are talking about . It is also one a few that Central Maine Power will accepted for approvel. The same is true for New Hampshire. I am liecensed in 3 states NH,Me,and Ma and install about 12 of these a year. No they don't switch the neutral but the uttillity companys along with the UL test this equipment. They just don't give thier aproval to equipment. And if they say to use this equipment then I use it. As for other Uttilitys or other states or countrys everyone needs to check thier local codes

Generator set up ideas wanted
Shop Tools
Replies 89 Post by steve4300

Thanks very much, I'll look into it.

cab enclosure
Kubota Tractors
Replies 3 Post by A.

This rig is owned by someone who frequents elsewhere. There was a detailed writeup about it there.

Tractor turned Fire Engine
New Holland Tractors
Replies 3 Post by AV8R

I hope you guys will be patient with me as I am currently entering my fast in solemn observance of "Tookie Watch".

Synthetic Hydraulic Fluid
Parts and Repair
Replies 83 Post by Chief

I don't feel so bad now. I don't know if it helped, but I hit the face of the male end on the post where the masts go, it has a little tit on it that retracts into the male end of the coupler and a little bit of hydraulic fluid spurted out all over me and my glasses. Maybe this was enough relief to get it seated into the female / tractor end. I didn't let much out. It was the first time the FEL was off of the tractor. Anyway, since I got it back together I'll muster up some courage and take it apart again sometime. I figure dropping the 3-point finishing mower can't be too hard after taking off the FEL.

Hydraulic Line Reconnect Issue
Loaders Back Hoes
Replies 12 Post by hugheswill

Mark, watch your tachometer closely when towing in this configuration. If you watch the tach closely, you will notice the rpms jump up about about 200 rpm without the transmission downshifting to a lower gear as you gradually add more throttle. This 200 rpm jump indicates that the computer has unlocked the torque converter and it is now in fluid coupling mode which generates serious heat. As you add more throttle to maintain road speed, the transmission will eventually downshift to a lower gear and you are correct. This adds to the problem.

Automatic Better Economy Than Manual
Pickup Trucks and Trailers
Replies 52 Post by Chief

Thanks to all and I think you're right about the magnetic heater, and I suspect the glue pads are about the same. WI is just to cold for them. I kept the package so I think I'll trade it for a block heater, messier to put in but I think better in the long run. I'll check the plugs/fuses this weekend. I'll keep you all posted.

Glow plugs
Jinma Farmpro Agracat Nortrac
Replies 14 Post by kalpia

Does anyone have any idea on why 3pt hitch wont lift? <br>
Used this e230 for a while and it suddenly quit lifting.<br>
Where is the fill and check points for hydraulic fluid? <br>
Any other advice would be greatly appreciated. Some control markings are in Japanese. Anyone know where to get an operator/service manual in english?<br>
<br>
Thanks<br>
Scrapiron

need help with hinomoto e230 3-point hitch
Hinomoto
Replies 4 Post by scrapiron

I hear ya Yoop. We got about 4" yesterday on top of the 1-2" from a few days earlier that I didn't clean up. I did get the rear blade on the CUT with the first snowfall but not without some issues that could have been avoided had I been a bit more pro-active.

I know what you mean by the wind. I'm in the country, on top of a hill with no trees big enough yet to block the wind. When it's bad enough, I wear a snowmobile helmet to keep the wind off my head and face. It works pretty good.

I love winter
Just For Fun Off Topic
Replies 17 Post by Iowafun

Gridiron, I have a NH TZ24DA with a 60"MMM, a 48" box blade, and a 6' rear blade. This is a good well built tractor. It's an excellent mowing tractor, which is my primary use.

However, I know the BX is also a good tractor and some of my friends who have JD's also have good tractors, even though you may tend to pay more for the green color.

Base your decision on your dealer, how each tractor preforms from a test drive, and what brand tractor is most prevalent in your area. If you buy green and most of the tractors in your area are orange or blue you may have delays with repairs and parts.

In spite of what JD Dave thinks, the NH, in my opinion, is one of the better looking tractors available. The new style lights not only look good but preform very well.

Good luck with your purchase, Dave

2305 massey 2300 or new holl tz25da
John Deere Tractors
Replies 12 Post by kyvette

I think it was the November 30th issue of the Wall Stree Journal that had an article exposing how worthless hybrid vehicles are. Apparently toyota is laughing at us.

I was thinking a corn burning hybrid would work that worked on a low setting recharging batteries while sitting in parking lots, etc. The corn burner could run turbines or flywheels. If it had a boiler or someother device, could it plug into your home or business and run giving an energy credit when not in driving use!

Can gasoline pickup be converted to burn E-85
Pickup Trucks and Trailers
Replies 24 Post by yooperpete

Does anyone make a snowblower for a compact untility tractor that mounts to the booms of a front end loader? It seems to me to be a simple solution, but I haven't been able to find anything out there.

Front end loader snowblower
Snowblowers / Snow Plows
Replies 18 Post by Snowbelt Denizen

Just mow in reverse. ;)

PTO Direction
Mowers Field and Finish
Replies 12 Post by kwschumm

anytime KT. It was fun finding those videos.

Tractor video
Just For Fun Off Topic
Replies 11 Post by Iowafun

I installed mine Randy. What do you need to know? I thought I posted a summary when it was installed. Gotta go find it.<br>
<br>
Edit: Found the thread where I reviewed the kit. Here's the link.

skid plate for 4600
John Deere Tractors
Replies 4 Post by kwschumm

I hooked my front and back lights on the underside of the rops, hooked into the tail light with seperate fuse and switch, one wire hot along the inside of rops, used thr rops as the ground, works fine,{rops up see the ground} {rops down see the stars} .paul

Wiring Rear Lights
Kubota Tractors
Replies 7 Post by tarbaby

good advise I will try those products I guess Wal-Mart will have them. liked your pics you have a nice place thank for the info.

Dextron II
Jinma Farmpro Agracat Nortrac
Replies 3 Post by pmp

They are suppose to debute it at the our dealer meeting and let us know when it will be available

New Kioti DK90
Kioti Tractors
Replies 9 Post by wallace