Go Bottom Go Bottom

John Deere 4410 Transmission Error Codes

View my Photos
TraktorTom
Join Date: Oct 2011
Posts: 3 Denmark
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2011-10-16          180912

My John Deere can either drive or reverse it comes up with error code 1 short 3 long 3 short 1 long flash.
Is there anyone who can tell me what is wrong ..


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John Deere 4410 Transmission Error Codes

View my Photos
kwschumm
Join Date: Feb 2003
Posts: 5764 NW Oregon
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2011-10-16          180918

One short, three longs means "the calculated value for the coil resistance exceeds the valid range due to open or short circuit".

Three shorts, one long is a throttle position potentiometer problem which means a voltage out of range problem.

Have you driven through tall brush recently? The wiring on these tractors is under the tractor and it is somewhat common for brush to tear at the wiring and cause problems. The first step to fix would be to crawl under the tractor and trace all the wiring you see looking for and correcting any damage. When it's working again make sure all the wires are tucked up high and strapped in tight. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John Deere 4410 Transmission Error Codes

View my Photos
TraktorTom
Join Date: Oct 2011
Posts: 3 Denmark
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2011-10-22          180979

Do you know anything about how to calibrate the tractor again, I was told that the reason it will not run is that it has gone out of calibration ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



John Deere 4410 Transmission Error Codes

View my Photos
kwschumm
Join Date: Feb 2003
Posts: 5764 NW Oregon
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2011-10-22          180980

I read about it in the technical manual once. Seems like there was pages of procedures, maybe some special tools. The basic calibration involves setting the min/max limits of the potentiometers for the pedals but the devil is in the details. ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


  Go Top Go Top

Share This
Share This







Member Login