Auxillary Hydralic valve and Lever
| JohnL4330
Join Date: May 2010 Posts: 3 N. California
|
2010-05-05 170550
I have a Kubota L4330 tractor and need to add an auxillary control valve and lever to turn my snow plow left or right.
The snow plow has already the hoses and cylinder. Any suggestions on control valve and were to connect?
Reply to |
Auxillary Hydralic valve and Lever
| Murf
Join Date: Dec 1999 Posts: 7252 Toronto Area, Ontario, Canada
|
2010-05-05 170552
John, first off, welcome!!!
As for your snow plow question, the answer requires a question, is the plow mounted on the loader or on the 3pth?
If it's on the loader there's very little except a 12 volt solenoid and a pair of couplers that you need to add.
Best of luck. ....
Reply to |
Auxillary Hydralic valve and Lever
| earthwrks
Join Date: Dec 2003 Posts: 3853 Home Office in Flat Rock, Michigan
|
2010-05-05 170553
Short of rigging up a selector valve coming off the loader if you have one, the best bet is to bite the bullet and buy a kit from the dealer. They can be pricey but you rest assured everything will fit and have all the necessary relief and load checks in it. ....
Reply to |
Auxillary Hydralic valve and Lever
| JohnL4330
Join Date: May 2010 Posts: 3 N. California
|
2010-05-06 170576
It is on the quick attack loader ( were the bucket can be attached)
The snow plow comes with a hydralic hoses and cylinder to pivot the plow left or right. ....
Reply to |
Auxillary Hydralic valve and Lever
| Murf
Join Date: Dec 1999 Posts: 7252 Toronto Area, Ontario, Canada
|
2010-05-06 170581
|
Quote:
|
If that's the case all you need then is a pair of 12 volt solenoid valves that diverts the fluid that goes to & from the bucket curl circuit to a pair of quick disconnect fittings.
You plug the plow into that pair of ports, flip the switch and use the side-to-side control of the loader control to angle the plow left or right instead.
Just be sure the plumbing for the plow includes some form of shock relief.
Best of luck. ....
Reply to |

Share This