Go Bottom Go Bottom

3 point arm is bent

View my Photos
pdmholmes
Join Date: Oct 2009
Posts: 12 Cowichan Bay, BC, Canada
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-10-24          166502

Hi, the pin at top end of my 3 point arm slipped out a bit and i ended up bending one side of the u shaped holding arm (while i was using the roto vator)
the holes now do not line up so the pin will not go back into the far hole
a thinner pin will just get through - does anyone think it will be strong enough to last?


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



3 point arm is bent

View my Photos
greg_g
Join Date: Jan 2004
Posts: 1816 Western Kentucky
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2009-10-25          166504

I doubt it. Makes more sense to straighten the u-connector. Why not just take it to a machine shop and let them realign the holes in a hydraulic press?

//greg// ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



3 point arm is bent

View my Photos
pdmholmes
Join Date: Oct 2009
Posts: 12 Cowichan Bay, BC, Canada
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-10-25          166505

interesting ....is it hard to remove the arm from the tractor - any tricks ? ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



3 point arm is bent

View my Photos
greg_g
Join Date: Jan 2004
Posts: 1816 Western Kentucky
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2009-10-25          166506

I noticed that you have this question in two places. Seeing as how your profile says you have a MF, I think that is the more appropriate place. I'm moving my respone over there.

//greg// ....

Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


  Go Top Go Top

Share This
Share This







Member Login