Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

My condolences 🙏 to the entire family 👪

My Father In Laws Passing
Everything and Anything
Replies 7 Post by rickeyc

Know exactly what you are taking about if my tractor isn't about perfectly level the collar feels like it's welded in place once it's leveled it will slide right back with no issues crazy. But been there done that!

Bush Hog PTO Shaft Stuck on Tractor
Mowers Field and Finish
Replies 9 Post by rickeyc

That sounds like a shim to align chains most likely was on inside cover fell off when you slide cover off as I'm assuming a shaft went threw cover where chains are?

Hinomoto Tiller
Hinomoto
Replies 3 Post by rickeyc

Not sure if you got a manual or a computer Zip drive of exploded view of your machine. I can not see it obviously so you would have to find out if it's shuttle drive hydrostatic or gear to gear why this is important is because your PTO chuck that enters casting goes probably on a spline shaft if so it should have a slip joint or a two piece coupling or a round shaft with key way or shear key so if for some reason you catch something inside say a brush hog it has break away points with these keys so it don't damage Main unit. If it has a key way and it's sheared it will turn the shaft but loose speed when throttled up as it will slip by where key would lock it in. I don't believe that 1010 has adjustment for PTO speed if you send me serial number I could look into it possible send you excluded picture of the unit and how it operates to see where your issue is. Sorry for long message.

Massey Ferguson 1010 PTO slows down on full throttle
Massey Ferguson Tractors
Replies 6 Post by rickeyc

sounds like there is air in your lines as air pockets will push the fluid to raise the bucket but when you lower the bucket the air pockets allow bucket to drop intervals probably 3 to 4 inches at a time!

loader hydraulics problems
New Holland Tractors
Replies 3 Post by rickeyc

There is a Screen in the end of the hard line from the pump to the proportioning valve I have seen the screen inside of the line get filled with gunk slow and stop the flow of fluid from the pump to make operation choppy, noise vibration in line and no tilt on bucket or raise of three point hitch

TC35DA hydraulic problem
New Holland Tractors
Replies 5 Post by rickeyc