Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

I agree with the previous posts. Also, if I have a dirty engine condition, I brush with kerosene and the hose off with water. I have had great results using a spray tire cleaner as mentioned above on my tractors, 4 wheel ATV's , etc. I find that the spray cleans hard to get at dirt and leaves a shinny/slick surface which makes it easier to keep clean. - <br>Bob

Washing and Cleaning a Tractor
Parts and Repair
Replies 11 Post by Bob Herman

The JD mechanic might be right. At only $40.00/hr I'd not only let him do it, I'd buy him lunch as well.<br> The usual reason for a leaky waterpump is that the bearing has angular play which allows the fanshaft to operate at a slight angle and wears out the seal. A typical rebuild is as you describe: always both the seal and bearing are replaced and sometimes the fanshaft as well (because it can be scored). <br> Radiator fins do not contain water, and can be bent and straightened many times without affecting the vertical tubes within the radiator - which is where the water flows. If this seems a worry, a sheet of thin cardboard taped to the radiator will protect the fins completely. <br> Support your local mechanic. Roger

JD 755 quot waterpump quot
John Deere Tractors
Replies 2 Post by Roger L.

Need parts list for old Allis-Chamers tractor and repair man.<br>if can find ,+ where do I find year maded

FSBO Simplicity amp Allis-Chalmers Garden Tractors Implements amp
Other Tractor Brands
Replies 9 Post by Aubrey L Sloan

On another thread we we discussing side slope stability and the concensus was that turf tires were more stable than the lug type on side hills. I wonder if this would apply to the R4 as well?<br>

R1 vs R4 on a JD 790
John Deere Tractors
Replies 5 Post by Roger L.

I own this exact tractor and loader. In 1991 I paid $9000.00 at an auction. It had 270 hours on it.It has ROPS on it and was made in 1986 according to the serial number. This tractor has performed flawlessly; one hydraulic cylinder on the loader popped a seal on a cold day and a retaining washer scored the ram.<br> I`ve seen this set-up advertised on a dealer lot 2 years ago for 13,000.00. I don`t know the hours that were on it and I assume the 13,000 was pre-dickering.<br> I`ve got 740 hrs on it now.I`m unaware of any sleeve/cylinder problems. The differential lock stuck in

of fillings.A drain plug with a magnet would make sense. Also the battery is in front of the radiator which has a "sceen-door"screen in front of it and debri building up will cause it to heat up,especially wading through timothy or mature thisthle.
"> JD 855 955 problems
New Holland Tractors
Replies 6 Post by RCH

Up till now in the utility tractor market John Deere had only four model 5210-5510, which carried almost any feature that you could want as standard equipment. However the competition had as many as 10 models in this area ranging from basic stripped down models to deluxe. John Deere is just expanding their line to compete. The advantage tractors are not between the 4000 and 5000, they are a 5000 with less features like:<br>-They don't come standard with draft sensing<br>-They have mechanically engaged wet disk brakes, instead of hydraulicaly<br>-Less Ergonomic operator station<br>-No options on transmission<br>-etc<br>However the base machine is still a very rugid utility tractor

John Deere Advantage Series
John Deere Tractors
Replies 2 Post by Jeff Kraft

My father was using my MF205 when the crankshaft let go (flew apart and the mechanic says the crank looks defective) This motor is a 2 cylinder diesel manufactured by Toyosha - model number S107. It's a 20 hp, 1070 cc. Anyone know what a new or used one would cost and where the best place to find one would be? The mechanic says that the crank took out a chunk of the block when it came apart and the block is not repairable (I find that hard to believe) It only had 510 hours on the meter.<br>any info would be greatly appreciated, Rich.

Need new motor for MF205
Massey Ferguson Tractors
Replies 2 Post by Rich S

The information that is available now is on our dealerships web page, www.jdlawns.com. The 990 is going to be like the 790 in marketing however not as many John Deere implements will be available for it. No Backhoe, and also no belly mower

New JD 990 model
John Deere Tractors
Replies 10 Post by Jeff Kraft

Art, it has been along time since I heard the phase tight ground but you are right. We refere to it as heavy soil (heavy pulling a culivator). I would like to slow the wheel rpm down but I believe the gearing is fixed. Any more suggestions. By the way you had more ideas than the dealers I talked to up here. I run the tines in slow and in reverse mode, wheel speed in low or 1st, and max depth (control bar set up at 7 inches)but the wheels still spin down and you have to push it to keep going. I sure think it is a great unit if I could only get it to work better. I have tilled the garden twice with it but still not happy with the job (deep and shallow depths). Thanks again

Kubota AT70s Rear Tine Tiller
Kubota Tractors
Replies 16 Post by Gerald

I would like to know if this

JD 4000 series front axles
John Deere Tractors
Replies 12 Post by Randy

I have seen them sold around here for $4000-4800 with a loader. I will say I don't see that many Fergusons with a loader.

Massey Ferguson 1951 T30
Other Tractor Brands
Replies 5 Post by bob

There are several things that are

Smoke
John Deere Tractors
Replies 13 Post by Ted

If you'd give me your email address , I can send you the prices. The address you gave won't go through.I don't think this forum should be used for posting parts prices. Contact me at sheaftractor@coiinc.com or 815-284-3226

Yanmar 140-D seat and silk decals Owners manual
Yanmar Tractors
Replies 4 Post by len

Can anyone tell me what would be a good (fair) price for a B1700 with front-end loader and brush hog. Has under 50 hours and appears to be near showroom condition. Thanks in advance.

kub B1700
Kubota Tractors
Replies 2 Post by F. Barton

Hi Steve<br>Thanks for the update. Tell us more about these new models.<br>mario

Kioti LB2204 and Kubota L2900gst just in Friday
Kioti Tractors
Replies 2 Post by mario

Dear Sirs,<br>can you promptly tell me what a 1994 Kubota 2650 with bucket is worth. It has 4wheel drive and recently had a new head gasket put on. it has 890 hours.<br>Your quick response is appreciated.<br>Neil

blue book for tractors
Other Tractor Brands
Replies 34 Post by neil simpson

It certainly sounds like a fuel problem. IMHO, either air or injector pump. If as many things were replaced under warranty as you say, I would have a serious fit if they suddenly

Engine Occasionally Starves for Fuel Slows RPM and Dies
Parts and Repair
Replies 2 Post by Norm

The only problem with mixing #1 is that you are going to reduce the horse power derived from the fuel. As stated, there are additives that reduces the cloud point without reducing the energy rating. I use DEE-ZOL+, there are others that I am not familiar with.

Diesel fuel in winter time gels
Parts and Repair
Replies 16 Post by Norm

Concur with Dave and David re hydraulic feed. Safer and lets you move brush while chipping. I have a Vermeer 6 in PTO chipper standard with hydraulic feed I run with a JD 1050. Had to build an adapter to lower lift pins so I could raise it high enough to get up a trailer ramp. The weight is all the 1050 wants but it does it. 4

PTO CHIPPER RECOMMENDATIONS
Operating and Attachments
Replies 11 Post by Eben

Have had a light weight rhino for about 20 years for drive maintenance and snow. Have used forbackfilling foundations and other odds and ends. Used first with a D-17 AC and since 83 on a JD 1050. Has done everything I wanted except autolevel. If you are going to do snow, you might want a as tall a blade as you can get.

Rear 84 quot grader scraper blade
Snowblowers / Snow Plows
Replies 3 Post by Eben