Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

I am looking at a couple 9960s, what are the pros and cons for you guys that have them?

Kubota M9960
Kubota Tractors
Replies 2 Post by air2rxb

Does anyone have a good drawing or repair manual to deal with the clutch system mentioned in the subject?

My Belarus MTZ82 have problem with the clutch
Belarus
Replies 2 Post by dotebygd1383

Hughow, how can I find out where to look for the case crack on the Deere 110 TLB. I’ve always wanted one because I like the size, power and the skid steer interchangeability. I’ve something about the case cracking but really can’t find any details about it. Hoping you can help. Thanks so much.
Mark k

Deere 110 verses Kubota L48
John Deere Tractors
Replies 12 Post by Bveau3

Has anyone used a Nortrac snowthrower... especially on a BX2350?

Nortrac Snowthrowers
Snowblowers / Snow Plows
Replies 3 Post by nathow

If the battery and cables are good the only real question mark left then is the starter.

I'd really advise taking it in to get checked.

Best of luck.

3600 diesel slow to crank white smoke from crankcase
Antique Tractors
Replies 7 Post by Murf

If it died out [u]after[/u] cutting 10 acres of grass it's a fuel supply problem.

I'm seeing issues with fuel line degradation the last while, I don't know if it's something their putting in diesel now to make it 'cleaner' or to make up for the lack of lubrication from the removal of sulfur or what. Basically the inner core of the rubber fuel line breaks down to the point it chokes off the supply of fuel to the engine. Usually shutting it down for a period of times allows the blockage to open allowing continued use, but only for a short period of time before it happens again.

It's a cheap experiment, change out all the rubber hose in the fuel system for new stuff and see if the problem gos away.

Best of luck.

Injection pump problems 1725
New Holland Tractors
Replies 4 Post by Murf

Art,
I did changed and tested the fuel solenoid. :(
There is fuel coming from part " No 120" on the drawing (before entering that engine block) but not fuel coming on the top where the fuel lines are connected to take fuel to the injectors.
There is a mechanical part on that block that can get clogged??

Kubota MX5000SU Fuel InjectorSystem
Kubota Tractors
Replies 5 Post by robpayan

I took my battery out and had it tested under load and it said to replace. So I did that and have only started it a couple of times so far, so really don't know if that fixes problem. Have been under the weather for a time and waiting for surgery on my mouth, have plugged saliva gland. I hope my problem is solved and thanks for your help.

J D 955 restarting problem
John Deere Tractors
Replies 10 Post by djauvdiyd

Unless the old engine suffered some pretty catastrophic damage I'd have to say a rebuild will be the easiest / cheapest way to go.

Best of luck.

Ford 3000 Ford 3600
Antique Tractors
Replies 3 Post by Murf

Discontinued

Equipment Manuals Now Available
Website Operations Howto
Replies 2 Post by DennisCTB

Wiring diagram lk3054

location of the slo blo fuse
Kioti Tractors
Replies 5 Post by tipoblanco

The freeze plug I replaced was near the center of the engine, behind the alternator and ahead of the starter. It was the one that is most accessible.

Cub Cadet 6284D Hydrostatic transmission slow speed
Cub Cadet
Replies 18 Post by boltboss

All of a sudden the starter motor will not kick in. Batteries are all OK but no action from starter motor - not even a click. What should I be diagnosing first and how. How do I jump start it bypassing the ignition switch? How can I test if the solenoid is getting power?<br>
Any help will be greatly appreciated.

Belarus 920 - starter motor will not activate
Belarus
Replies 3 Post by ozebee

My DK45 Hydraulic dash light is on so I changed filter and fluid but still on. Would appreciate any help diagnoising why.

DK45 Hydraulic dash light
Kioti Tractors
Replies 2 Post by kkimes

I have some surface breakup on the garage floor. I had used the epoxy paint with the traction flakes. Nice at first but could not take the winter tires, salt, gravel and water. So it flaked the flakes and paint chips every where the tires were in contact. A real mess. I was thinking I would use a leveler or epoxy cement to redo the surface but am dubious of the tire traffic doing the same to it.

Concrete Salt Etching
Home Improvement
Replies 11 Post by DennisCTB

What is the availability to replace the shaft assy with pin

MF 25 PTO Shifter
Massey Ferguson Tractors
Replies 2 Post by be18dog1

Thanks for your input. I did take them to a place near me that said they could fix them. I have no idea what the cost will be but I still have to take it to the dealer to get the new pivot pin installed. I have no way to safely do it myself. I don't know what will happen when the pin is pulled. I've never had to replace them before. Don't know if the top pin will hold it together or whether I will be wearing it all the way to the hospital. I do a lot of tree cutting since the Ash Borers have taken over my woods. I haven't had a good track record with the dead ones. Probably save a lot of pain and money by letting them do it. My dealer is pretty good, he'll work with me on it. He knows the situation, said if New Holland won't make it right he'd make it right with me. I'm fairly sure he will. Pretty good to me so far. I think his hands are tied because of the service rep. I would pay to talk to him.

New Holland 930GH backhoe
New Holland Tractors
Replies 5 Post by justjim

Hey, thanks for the part number. Much appreciated.

John Deere 955 Pto problem
John Deere Tractors
Replies 8 Post by thelastsumur

Memory is not what it used to be but I believe those were built by hinimoto of china.

Suzie 150 4x4
Mitsubishi
Replies 2 Post by Art White

Thanks for the reply. I went to a local dealer and got the info I needed and the fluids.

B6200D 4x4 fluids
Kubota Tractors
Replies 3 Post by gregjo1948