Tractorpoint Login

print < Tractorpoint Login

Search for = jarndt

Topic

I hate to give advice on how to cheat the system, but I like to take into account the spirit of the rules vs. the letter of the law. If the link isn't too long or complex, just type it into the body of the message without the http prefix and substitute the word "dot" for each "." There's still a chance the filter might catch it though. Don't get me wrong, its not as if you're trying to do anything improper if the filter is simply there to filter out spam.

Subj Any Way
Kubota Tractors
Replies 7 Post by jarndt

suggestion...

Tape that fuse into its holder with electrical tape. Mine came loose, but was still in the holder causing my tractor not to shut off when I turned the key. Fortunately it was only an annoyance for me, but it could have been a major safety issue (i.e. the operator presence switch was not working either).

Kubota BX23 slow blow fuse
Kubota Tractors
Replies 3 Post by jarndt

I've pondered the same thing. Best I can come up with (not that I have actually done anything yet) is buying a small plastic toolbox and mounting it on the crossbar behind the seat with u-bolts. The crossbar is flat on the 1830, 2230, and 23. It is raised on the 1500 which might make things a bit more tricky. The next best thing might be a simple pvc tube with one fixed end cap and one removable end cap mounted vertically to the ROPS with band clamps. Just make sure to drill a drain hole in the bottom.

Storage bucket for BX Tractor
Kubota Tractors
Replies 12 Post by jarndt

Get a set of skid shoes for your blade. They are very helpful on a gravel drive. Otherwise, you can turn the blade around and push with the back side. The weight of the blade should keep it from riding up over the snow. Of course, be careful about using the diff lock in 4WD. Attempting to turn while the diff is locked can cause major geartrain damage!

Tire Chains
Kubota Tractors
Replies 6 Post by jarndt

For the $$$ you saved on that deal, you could easily go buy a brand new FEL at your dealer and still be ahead!

BX2230 with FEL 60 MMM and rear grass catcher
Kubota Tractors
Replies 25 Post by jarndt

The magnetic type has several advantages... For one, it can be taken on and off easily if you install a quick disconnect electrical connection. Secondly, it will "break away" if you run into something inadvertently. Third, it can be repositioned/re-aimed more easily than a fixed mount light. However, a fixed mount system will probably hold its aim better.

Compact Tractor Lights on ROPS
Kubota Tractors
Replies 18 Post by jarndt

Well said. A typical homeowner or hobby farmer is never going to see a monitary ROI. The only exception being sweat equity with the aid of your machine (in place of a paid contractor) to increase the value of your property. But that doesn't say anything about the value of personal enjoyment! Heck, I'd rather go out and play in the dirt than drop $200 on a trip to an amusement park any day!

OK How do you Justify your Tractor
Kubota Tractors
Replies 33 Post by jarndt

I would have to agree with that. The brake pedal on BX machines is in an awkward position (not that I have a better suggestion). However, in my experinece it has plenty of holding power. Of course, with a hydro you only need the brake to hold your position on a slope or set the parking brake. The hydro tredal takes care of everything else.

Have you discovered this about your BX23
Kubota Tractors
Replies 26 Post by jarndt

I'm looking for an economical source for a front weight kit on my BX1500. Suitcase weights or stacked plates, preferably a commercial product available for purchase. (I can do the homemade thing, but I'm looking for something professional) The kubota kit is quite expensive. I'm sure there are other sources out there, but I don't know where to find them. Any help would be great!

Front Mounted Weights
Kubota Tractors
Replies 2 Post by jarndt

If the slope isn't too steep and the grading isn't bad a BX2230 w/ box blade would be perfect. If more heavy-duty grading is needed a B7800 with more weight and power might be better. The BX machines are surprisingly capable for their size. Engine power really isn't a problem, but the tradeoff is weight.

What Model is best for me
Kubota Tractors
Replies 5 Post by jarndt

I think it was one of the tabs that accepts the mounting pin on the lift arm. Next time I will roll the deck as far forward as possible before sliding it sideways.

BTW, my dealer also cautioned me about making sure the driveshaft is fully connected. He said he's replaced a few tranny housings as a result of a PTO shaft coming loose at 2200RPM. Not pretty.

Is there any way to change the hydro filter without loosing all the fluid? I'd like to replace the dented filter with a new one out of good measure, but I just replaced the fluid 6 hours ago and I don't want to waste it.

Hydro Fuild Filter on a BX
Kubota Tractors
Replies 3 Post by jarndt

Ducati,

I used to have a WheelHorse with a front blower simlar to your Cub. I remember having all kinds of problems with traction, even with rear chains. That blower would just "suck" you sideways right into snowbank. You were totally SOL on any kind of slope. I praised the gods when I replaced it with my BX. Even though I'm only using a rear blade vs. a blower (too much $$$), the 4WD makes things happen.

Winter traction on a Kubota B2910
Kubota Tractors
Replies 17 Post by jarndt

Curtis Cabs makes a variety of options incl. full glass enclosed hard cabs, soft-sided cabs, canopies, & simple sun shades. There are other companies out there with similar products too. Get ready to spend some bucks though. I know hind sight is 20/20, but a factory cab is almost always the best choice.

Weather Brake for Kubota L3830
Kubota Tractors
Replies 6 Post by jarndt

Sounds like an interesting engineering project. I wish mine had been that interesting.

The reason tractor weight wasn't a significant factor is because CG calculations factor in mass right from the start. Raw weight really isn't seperable as an independent variable.

Rear wheel spacers for B2710
Kubota Tractors
Replies 18 Post by jarndt

The heavy stuff is really where a hydro can show off. You can slow the forward speed down to almost nothing which effectively frees up more engine power to the PTO. Slower forward speed also means the hog is taking less material at the same time as the PTO is getting a "power boost".

Help with L2350
Kubota Tractors
Replies 5 Post by jarndt

Go with the 4'. Most importantly, it will be more stable on slopes. Also, you won't see as much engine bogging in the thick stuff. My uncle has an L2250 (21 PTO HP) and it handles a 5' unit fine, but tends to bog down in thick brush.

Bush Hog sizing
Kubota Tractors
Replies 5 Post by jarndt

You're right, it should not leak. But the problem might be simple. Try to trace the drip back to its origin and call your dealer.

New Kubota Dripping
Kubota Tractors
Replies 5 Post by jarndt

Thanks for the good advice, Art. (as usual!) Do you know of any specific manufacturers that make smallish spreaders. Mind you, I'm not asking for any endorsements, just other options to check out. The TSC XB spreader is a bit pricey and has a long lead time. I'd like to pick one up before it is too late for fall fertilizing.

BX Sized Broadcast Spreader
Kubota Tractors
Replies 7 Post by jarndt

I know about filling tires with calcium or antifreeze, but I don't know anyone with foam filled tires. Does it add weight? Does the foam break down over time? Where would one go to have tires filled? Cost?

B7510 feels tippy
Kubota Tractors
Replies 11 Post by jarndt

You could also try white LED lighting. They are super bright and use a lot less power. Tradeoff is cost. It would likely be less expensive to simply upgrade the alternater.

LIGHTS AND LIGHTING
Kubota Tractors
Replies 24 Post by jarndt