4300 3 point slow to lift
oldned
Join Date: Dec 2007 Posts: 3 4400 peaceful glen rd vacaville ca 95688 |
2008-02-08 151194
Hi, My 4300 3 point lift rases very slowly and requires high throttle to lift. also the lift lever is very hard to move.
I (dumb) did operate it with the drop rate valve closed.
Any help would be greatly aspreeciated,
Thanks, Fred
Reply to | Quote Reply | Add Photo
4300 3 point slow to lift
kthompson
Join Date: Oct 2005 Posts: 5275 South Carolina Pics |
2008-02-11 151244
oldned, did it act this way before you tried operating it with the valve closed? or has it been long enough you are not sure?
Have you looked to be sure there is nothing binding in the linkage or a little limb or such in there, have you tried oiling the linkage, have you checked the fluid level, if your tractor has power steering or Hydro trans are they operating normally or they slow or jerky? kt ....
Reply to | Quote Reply | Add Photo
4300 3 point slow to lift
oldned
Join Date: Dec 2007 Posts: 3 4400 peaceful glen rd vacaville ca 95688 |
2008-02-12 151279
Mr kthompson, thanks for your reply. I found the problem the adjusting nuts on the lift handel linkage had loosend to where thier was about one and a half inches beetween them. After I set the lift arm height and tightened the nuts everything works fine.
Thanks again, Fred ....
Reply to | Quote Reply | Add Photo
4300 3 point slow to lift
kthompson
Join Date: Oct 2005 Posts: 5275 South Carolina Pics |
2008-02-12 151284
Oldned, WOW, "Mr" not many use it today. Respect is a lot art.
Sure am glad it was minor. I have one tractor I have to keep oiling the linkage on it will tend to rust tight. kt ....
Reply to | Quote Reply | Add Photo
Go Top
Share This