Go Bottom4210 PTO not Engaging
 | SeonSr
Join Date: Mar 2006 Posts: 7 San Andreas, CA 
|
2006-05-16 129443
I thought I posted this yesterday but don't see it so I'll post again.
I've owned this 4210 for three years and never needed to use the PTO until yesterday when I connected the recently acquired Taylor Ways Backhoe. The PTO controlled with a pull/push knob located on the right side besides the 3 pt slide control.
At any rate the PTO does not engaged. I've checked for loose or disconnected wiring underneath the floor board but didn't see any.
I've checked for loose or disconnected wiring underneath the floor board but didn't see any. When I pull the PTO knob t engage the PTO, the dash light comes on and when I lift myself off the seat, the engine cuts off so that tells me that the wiring is good.
I was told that the solenoid maybe bad so how do I test that? How do you remove the solenoid...unscrew it or it it a plug in type that's "lifted off" the 2"x5"x1-1/4" rectangular housing?
Reply to |
Quote Reply |
Add Photo4210 PTO not Engaging
| SeonSr
Join Date: Mar 2006 Posts: 7 San Andreas, CA
|
2006-06-01 130257
Well the tractor went to the dealer and they found the solenoid connector wiring was faulty. $86/hr got my PTO going. ....
Reply to |
Quote Reply |
Add Photo4210 PTO not Engaging
 | kthompson
Join Date: Oct 2005 Posts: 5275 South Carolina 
 Pics
|
2006-06-02 130267
You hit something here that must please some mfg and dealers: the number of machines sold that get low use and run out of warranty before some defects are found.
I recently had a much higher cost experience with another brand that had the machine been run near normal hours it would have happened during warranty period.
....
Reply to |
Quote Reply |
Add Photo4210 PTO not Engaging
 | Art White
Join Date: Jan 2000 Posts: 6898 Waterville New York
Pics
|
2006-06-02 130280
Ken, you are right with pleasing some dealers but not all! I hate it when that happens! ....
Reply to |
Quote Reply |
Add Photo
Go Top
Share This