MF245 Hydraulic problem
gprimeau
Join Date: Sep 2011 Posts: 2 Pontypool, Ontario |
2011-09-05 180195
I have an MF245 with a loader ( 1977 model). My issue is that a few days ago, the 3 pth hydraulics stopped working properly. When I put the lever (under thre seat) in the loader position, the loader works fine. When moved to the 3 pth position, the 3 pth arms stay in the full "up" position no matter where the lift arm and/or draft arm are positioned. The only way to lower the 3 pth is to fully depress the clutch and let the implement weight drop it. This occured as I was cutting brush with a bush-hog and it had been working properly until then. Hydraulic oil is new and full. Any assistance would be appreciated.
Reply to | Quote Reply | Add Photo
MF245 Hydraulic problem
kthompson
Join Date: Oct 2005 Posts: 5275 South Carolina Pics |
2011-09-09 180293
Might not apply to your tractor but suspect it does. MF did have two styles of remote hyd on some models. One cost less and was a dealer installed package or so have been told. Any way the 3 pth does not work when it is set for the aux (FEL for you) is set to work. It remained in the fully raised potion. The location of the lever makes me think you have the dealer added valve system for they had think two levers under the seat but have only seen those for rear remotes. ....
Reply to | Quote Reply | Add Photo
MF245 Hydraulic problem
shona13
Join Date: Mar 2012 Posts: 32 Western Australia |
2012-03-18 182788
Hi .
Check the response lever on the right hand side plate where you check the transmission oil make sure the lever is somewhere in the middle of the range,if the response lever is all the way to the slow position it may not allow the linkage to drop this is an easy one to check first ,let me know what you find .
Regards
Hutch. ....
Reply to | Quote Reply | Add Photo
Go Top
Share This