Tractorpoint Login

print < Tractorpoint Login

Search for = JerryG

Topic

That is a normally problem with that model of tractor and the 100 series. Instead of me typing the fix out, just look at Big Dean's page. It will tell you what you need to know for this problem as well as several other things. The good thing is that it is an easy problem to fix. I have done it several times over the years. <br>
Click on the below link.

gear shifter stuck
Massey Ferguson Tractors
Replies 5 Post by JerryG

Yes, a mid PTO was available. Matter of a fact I have a new gear box for the mid PTO in my extra parts. I can't tell you what they are worth, but you can look at tractorhouse.com for prices. I had a MF 1250 for a few years. It was a good tractor.

Massey Ferguson 1240 Mid Mount PTO
Massey Ferguson Tractors
Replies 3 Post by JerryG

Anyone know what model number the jd 750 engine is

jd750n engine type
John Deere Tractors
Replies 3 Post by jerrygallo

I don't know the layout of your place, but any area that is over about 15* needs to be traversed up and down only. Even at 15* you have to make sure that there is no large rocks,logs or dips. An obstacle like that can change the angle from safe to dangerous really fast.

Holy Tip over BATMAN
Kubota Tractors
Replies 13 Post by JerryG

All you have to do to flush the hoe is to leave the return end off of the line. Then move all of the control levers. That will flush the backhoe completely. As you extend and retract the cylinders there will be quite a bit of fluid that is expelled. You will need a suitable container to catch the oil. There is no reason for the tractor to over heat. It sounds like your dealer just wants to sell you some more expensive stuff. I didn't realize that you were wanting to put it on a Kubota, but that doesn't make any difference. The kit that you would need is called a power beyond kit. It allows the two backhoe hoses to be attached to the tractor.

Massey 1217 backhoe hookup
Operating and Attachments
Replies 9 Post by JerryG

The best engine heater that I have ever used is a tank type heater. The only problem with a tank heater is that they take up more room than other heaters, but they work better. They heat the water and circulate it through the motor. You can touch anywhere on a engine when it is 0 degrees out and it will be warm.

What is a good block heater
Kubota Tractors
Replies 13 Post by JerryG

I don't know if it is common for the GC2300 or not, but you may have to have the RPM's up some.

GC2300 2350 Loader
Massey Ferguson Tractors
Replies 5 Post by JerryG

First thing to always check is to see if all of quick disconnects are connected properly. Sometimes brush can grab one and almost disconnect it. It may look connected right and not be.

Loader hydraulic problem
New Holland Tractors
Replies 6 Post by JerryG

Which transmission do you have?

1233 Compact Tractor Noise when PTO is engaged and Clutch is mashed
Massey Ferguson Tractors
Replies 6 Post by JerryG

Make sure the tooth is seated real well, then tack weld it on both sides. I have done them this way for years and it works. If it is not seated good, you will break the tack when you go to use it. It it is seated good, you won't have any problems.

Backhoe Tooth Cover
Loaders Back Hoes
Replies 14 Post by JerryG

I have seen them and spoke with him about his inventory.

Agracat rumor
Jinma Farmpro Agracat Nortrac
Replies 13 Post by JerryG

Just wanted to let you know that I finally purchased a TC-30 4x4 with hydro, fel,hd bucket and cutting edge plus block heater from Buffalo Tractor in NY. They were best price around. Total cost to my house in CT 16100.00 which included 400.00 shipping. Thanks to everyone for their advice helping me make this decision.

TC-30
New Holland Tractors
Replies 5 Post by JerryG44

A tranny with creeper gears will engage without the clutch.

stuck clutch on Agco Allis tractor
Parts and Repair
Replies 14 Post by JerryG

I am presently dealing with Buffalo Tractor. TC-30, 4x4, hydro, R-4's 7308 loader with HD 60" bucket-$15,460.00. $400 shipping to CT and no sales tax. Corriher was also very good and just as pleasent to deal with, however their price was $15,875.00 plus $800.00 shipping and no tax for exactly same set up. Another thing to consider Buffalo says they will deliver with a trailer with ramps. Corriher says to have a flatbed standing by or some other means of unloading a hassel I don't want to deal with. It all adds up -let you know how I make out.

TC30 price
New Holland Tractors
Replies 25 Post by JerryG44

If you look at a compact Mahindra and then look at a MF 1200 series(Iseki TK models) you will notice that they are a like. The Mahindra compacts are Iseki from the fire wall back. The engine and front axle are of some other orgin as far as I can tell.

TYM and Terramite Tractors
Other Tractor Brands
Replies 39 Post by JerryG

They have both on there now, but they still have very little information on either in my opinion.

Gear or Hydrostatic
Operating and Attachments
Replies 54 Post by JerryG

harvey,
That is a very good cash crop. If you can pull of one crop you can retire. Last week, about a half a mile from my house the sheriff made a raid. They picked 13,000 plants.:)

returns per acre
Parts and Repair
Replies 16 Post by JerryG

There is not a Massey cross over for that model.

Isiki Tractors
Other Tractor Brands
Replies 12 Post by JerryG

The MF backhoe for your tractor is a fine piece of equipment. I have had one for about three years now and you wouldn't believe what I have dug through. It digs through very hard clay and flint rock very well. The sub-frame is made to attach to your MF mid loader mount. You will notice a hole below the loader on the mount on each side, that is where the sub-frame pins on. Those are the only two pin locations to attach the backhoe. The installation and removal will only take about 15 minutes after you get use to it.

Backhoe for Massey
Loaders Back Hoes
Replies 3 Post by JerryG

Mark,
They do have some similar designs. But I am like you I don't know which came first. I would assume that both have been in production prior to coming to USA.

what HP or tractor should i look into for a hunting club
Other Tractor Brands
Replies 18 Post by JerryG