Farmpro Jimna 2003 2425 tractor hydraulics
pickinpough
Join Date: Sep 2010 Posts: 24 Scottsbulff Nebraska |
2014-12-28 191727
Here is what I got.This summer I changed the screen filter and hydro fluid in my tractor (AW32) I also rebuilt the power steering sector and replaced the four loader bucket hydro lines. The 3 point doesn't want to work right and in cold weather it doesn't even want to come up. 30 min warm up time and at high idle it will start to come up. If I raise the bucket the 3 point drops. If I raise the bucket mid way the 3 point works better and doesn't seem to drop off unless I try to use it when the bucket is near the ground. I have a knob to adjust hydro psi under the front seat but now I don't remember where I should have it set. before I did all of this preventive mnt it worked fine. I did remove the screen filter again to insure I didn't miss a plastic plug and the steering sector work great. I rebuilt it because it would drift straight again on a left turn. I don't think this fluid is to heavy for Nebraska weather. Any suggestions?
Reply to | Quote Reply | Add Photo
Farmpro Jimna 2003 2425 tractor hydraulics
lsheaffer
Join Date: Jun 1999 Posts: 1082 Northern Illinois Pics |
2014-12-28 191729
I don't know what the Chinese recommend for hydraulic oil.Some of the Japanese recommended 80w-90 gear oil. Put a tee in one of your bucket hoses & install a pressure gauge. Read the gauge when the cylinder comes to the end of the stroke. Check this against the factory specs. ....
Reply to | Quote Reply | Add Photo
Go Top
Share This