MitsuD3259Fd Hydraulic problems
GERALD
Join Date: Mar 2006 Posts: 8 Washington State |
2006-03-22 126528
Howdy: I just bought a Mitsu D3259FD in January. Everything worked fine. I put it in the barn and didn't use it until now. The hydraulic system doesn't work. I drained the hydraulic oil and replaced it. ISill doesn't work. Is there anything else I can Do other than replacing the pump? Any ideas are greatly appreciated.
Reply to | Quote Reply | Add Photo
MitsuD3259Fd Hydraulic problems
lsheaffer
Join Date: Jun 1999 Posts: 1082 Northern Illinois Pics |
2006-03-25 126662
there is probably a pickup screen in the transmission behind the suction line. It may be dirty. You can also loosen the pressure line at the pump & see if it pumps any oil. ....
Reply to | Quote Reply | Add Photo
MitsuD3259Fd Hydraulic problems
GERALD
Join Date: Mar 2006 Posts: 8 Washington State |
2006-03-28 126757
Thanks for the ideas,but they didn't solve the problem. I noticed that the oil level in the tranny is lower than the pump. Does that make a difference in operating the hydraulic system? ....
Reply to | Quote Reply | Add Photo
MitsuD3259Fd Hydraulic problems
lsheaffer
Join Date: Jun 1999 Posts: 1082 Northern Illinois Pics |
2006-03-28 126762
When you loosen the pressure line at the pump, does it pump any oil out? If you have a model with a fitting in the top of the suction line at the pump you could pour oil in there to make aure you have a prime. If it doesn't work after doing that it sounds like it is a pump problem. I can supply you with a pump ....
Reply to | Quote Reply | Add Photo
MitsuD3259Fd Hydraulic problems
GERALD
Join Date: Mar 2006 Posts: 8 Washington State |
2006-03-30 126885
I just ordered a new pump from you. I would still like to know about how long is the spline on a pump like this one for the D3250FD? Any Ideas ....
Reply to | Quote Reply | Add Photo
MitsuD3259Fd Hydraulic problems
lsheaffer
Join Date: Jun 1999 Posts: 1082 Northern Illinois Pics |
2006-03-30 126900
The drive should be 14mm 12tooth with a 1.38 ext. from the mounting surface.
....
Reply to | Quote Reply | Add Photo
Go Top
Share This