Go Bottom

TC35DA hydraulic problem

View my Photos
massfarmer
Join Date: Aug 2014
Posts: 3 massachusetts
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2014-08-10          190882


I cannot raise the 3PH. Also, front bucket raises and lowers very slowly. I can't change the angle on the bucket using the remote control. PTO works fine and hydraulic fluid level is good. Can someone suggest a possible cause of these problems? Thank you.



Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



TC35DA hydraulic problem

View my Photos
Art White
Join Date: Jan 2000
Posts: 6898 Waterville New York
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2014-08-11          190887



Have you changed the filter recently? ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



TC35DA hydraulic problem

View my Photos
massfarmer
Join Date: Aug 2014
Posts: 3 massachusetts
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2014-08-24          190988


I just replaced the filter and topped off the hydraulic fluid. Still can't raise the rear lift arms or adjust the angle on the front bucket. Any suggestions? ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



TC35DA hydraulic problem

View my Photos
hobbyfarmer
Join Date: Oct 2014
Posts: 2
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2014-10-11          191204


Hello massfarmer, try this, pull your boot up, that is around your loader joystick. Look down in there, and you should see what looks like the head of a bolt, but is actually a plug. unscrew that and look down in the hole and see if that threaded plug has came out of it's hole . If so get a allen head socket and thread it back in the hole. I have a TC45 and that was all that was wrong with mine. Good luck ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



TC35DA hydraulic problem

View my Photos
rickeyc
Join Date: Jul 2016
Posts: 9 Orange Mass
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2016-07-03          195429


There is a Screen in the end of the hard line from the pump to the proportioning valve I have seen the screen inside of the line get filled with gunk slow and stop the flow of fluid from the pump to make operation choppy, noise vibration in line and no tilt on bucket or raise of three point hitch ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


   Go Top


Share This







Member Login