Go Bottomjohn deere clutch
 | declid
Join Date: Oct 2009 Posts: 6 davie,fl 
|
2011-04-14 177963
hi guys, looking for the tread size to make tool to pull the clutch, torque converter , on a gator with kawi engine 4/2
Reply to |
Quote Reply |
Add Photojohn deere clutch
| psshd1
Join Date: Apr 2011 Posts: 5 Southeast Pa.
|
2011-04-16 177990
I strongly suggest to buy the proper tool from JD or take the engine to a dealer and have them remove the clutch. The JD tool is made of hardened steel, any home-made tool could bend and or get stuck causing more expenses. ....
Reply to |
Quote Reply |
Add Photojohn deere clutch
| declid
Join Date: Oct 2009 Posts: 6 davie,fl
|
2011-04-18 178040
i would not take some thing to john deere, every other make u can get answers to, except JOHNDEERE, i found the bolt size, screwed it in ,one tape from the hammer, it popped right off, the bolt needed is a 9/16 sae thread, tom, davie ,fl ....
Reply to |
Quote Reply |
Add Photojohn deere clutch
| sfonger
Join Date: May 2011 Posts: 3 Ontario
|
2011-05-02 178291
declid:
Could you provide more detail on the bolt you used to pull the clutch off with? I assume it was 9/16 sae fine thread? What length of bolt? Did you use an additional smaller bolt as a spacer if the threads were too short on the 9/16 bolt?
Steve ....
Reply to |
Quote Reply |
Add Photojohn deere clutch
 | cedyedy
Join Date: Jun 2011 Posts: 25 santa Rosa CA
 Pics
|
2011-06-12 178969
HI Declid I am with you, I was given a JD Gator and I can not get Enything out of JD except inflated Prices There is a lot one can do without going to JD, You can rent the tool I think Once I sell My JD gator I will not go with JD again, I have asked for help several times from JD with no responce except Take it to a dealer ....
Reply to |
Quote Reply |
Add Photojohn deere clutch
| jdeere50
Join Date: Jun 2011 Posts: 4 south jersey
|
2011-06-13 178979
I'm curious how you make out with the R&R of the clutch, in case I have to remove mine. I'm fortunate, a few of my neighbors work at the local JD dealership.. ....
Reply to |
Quote Reply |
Add Photojohn deere clutch
| sfonger
Join Date: May 2011 Posts: 3 Ontario
|
2011-06-13 178982
I used a neighbours 9/16 fine thread bolt about 2 or 3 inches long as well as cutting an inch off the original bolt that holds the clutch on and cut a slot in the end for a screwdriver in case bolt did not turn out easily. So I used the 9/16 bolt to turn against the shortened bolt and tightened, then a hit with the hammer and off it came. I then went and bought a replacement bolt to hold the clutch on at a bolt supply business.
Steve ....
Reply to |
Quote Reply |
Add Photo
Go Top
Share This