Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Hello snow time again.I mounted a 7-6" meyers plow to the front of my l2250 kubota so as it can be removed with 2- 3/4" pins and one 1/2" nut it takes roughly ten minutes to hook it all up, with the angle hoses.The frame of the plow was cut after placing the frame in the bucket and measuring to make sure it would angle without hitting the bucket then a length of 2" square tubing was fitted with two ears welded 90 degrees to the tubing , which are paralell to the sides of the bucket and two 3/4" holes drilled thru both the ears and the bucket I also welded two 1/2" thick plates to the outside of the bucket for strength.the pins were in stalled and a piece of 1x4 -u channel was welded under the original plow frame to push against the cutting edge so as to not put the force on the pins and a strap mounted tru it to keep it from rolling when the loader arms were lowered.I took hy hydraulic from the accesary block under the seat to operate the two way valve for angling the plow. we push some heavy snow here in the hills of central Ma. no problem so far.

Snow Plow on Tractor
Snowblowers / Snow Plows
Replies 31 Post by PKtoolman

I purchased a 1985 L2250dt with a woods 750 backhoe and a bushhog 6 ft mower for 10500.00 it had 800 hrs on it and the clutch is great,I had to put on a set of rear tires ,badly cracked from dryrot and under pressure,but the machine runs great, hope this helps.
PKtoolman

I 039m in the process of purchasing a used L2350DT
Kubota Tractors
Replies 2 Post by PKtoolman