Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Cialis has been found to help with prostate. There are two dosages that are daily dosages of 2.5 and 5 I think mg. At least in the USA those dosages are normally covered by health insurance for the prostate health. There is a generic of it. Good RX also helps on its cost with some pharmacies, Kroger being one. About $20 per 90 day supply.

How to deal with Nocturia -Nocturnal Urination
Everything and Anything
Replies 5 Post by kthompson

My battery was just the Oem 2008 TYM battery(not sure what the name was on it cause I am seriously lacking in South Korean literacy) paired with a "Battery Tender" brand waterproof automatic battery charger.

SURVEY How often do you change your Battery
Parts and Repair
Replies 13 Post by grut212

He loved his job. Driving a train had been his dream ever since he was a child. He loved to make the train go as fast as possible. Unfortunately, one day he was a little too reckless and caused a crash. He made it out, but a single person died. Well, needless to say, he went to court over this incident. He was found guilty, and was sentenced to death by electrocution. When the day of the execution came, he requested a single banana as his last meal. After eating the banana, he was strapped into the electric chair. The switch was flown, sparks flew, and smoke filled the air - but nothing happened. The man was perfectly fine.

Well, at the time, there was an old Bulgarian law that said a failed execution was a sign of divine intervention, so the man was allowed to go free. Somehow, he managed to get his old job back driving the train. Having not learned his lesson at all, he went right back to driving the train with reckless abandon. Once again, he caused a train to crash, this time killing two people. The trial went much the same as the first, resulting in a sentence of execution. For his final meal, the man requested two bananas. After eating the bananas, he was strapped into the electric chair. The switch was thrown, sparks flew, smoke filled the room - and the man was once again unharmed.

Well, this of course meant that he was free to go. And once again, he somehow managed to get his old job back. To what should have been the surprise of no one, he crashed yet another train and killed three people. And so he once again found himself being sentenced to death. On the day of his execution, he requested his final meal: three bananas.

"You know what? No," said the executioner. "I've had it with you and your stupid bananas and walking out of here unharmed. I'm not giving you a thing to eat; we're strapping you in and doing this now." Well, it was against protocol, but the man was strapped in to the electric chair without a last meal. The switch was pulled, sparks flew, smoke filled the room - and the man was still unharmed. The executioner was speechless.

The man looked at the executioner and said, "Oh, the bananas had nothing to do with it. I'm just a bad conductor."

Joke o the day
Just For Fun Off Topic
Replies 73 Post by chuckles

This was posted by Candoarms awhile ago , might help!

[i]
Issues of this type are usually related to cavitation problems taking place in the hydraulic pump.

Cavitation can be caused by several things, either individually, or through a combination of things.

Air bubbles in the oil, caused by cavitation, will make it nearly impossible for the pump to develop any useful oil pressure. I have a good feeling that this is your problem, due to the fact that your pump seems to be working fine when cold.

Cavitation can be caused by starving the pump of fluid, which happens when you have a plugged sump screen. It can also be caused by using the incorrect hydraulic fluid. Hydraulic fluids containing detergents will quickly foam up, preventing the pump from building pressure. Water in the oil can cause these problems, as well.

When troubleshooting hydraulic problems, many people jump immediately to the pump as being the culprit, but this is rarely the case.

When was the last time you performed a complete fluid and filter change? Are you using the proper fluid? Have you attempted to remove and clean the sump screen.....provided this applies to your tractor?

[/i]

Nortrac NT 404 hydraulics randomly quit working then resume
Jinma Farmpro Agracat Nortrac
Replies 5 Post by minimac

Probably need more info to help, what model? Manual or Hydro?

New Holland 4 WD disengaged
Parts and Repair
Replies 5 Post by minimac

[QUOTE=bentlyf1;200942] Unlike Road tires there are no wear indicator on my tractor tires.They are 18 years old no dry rot but they and definitley worn bu not worn bald.Do most wait for the tred to have bald spots before replacing.I also sa that I can buy them online.But I also heard if I do that the tires com COMPRESSED so they a PIA to get mounted even at a tire store.Where I heard they blast them on with a propane burst.Any advice appreciated! [/QUOTE]

Tires that are old are dry and loose traction even they still have tread showing. If you on totally flat dry land you can use them until they die. But if you have inclines, wet surfaces, or snow you better get rid of them now.

On the install I woul call a couple tire places to see if they can install a tire that wa compressed for shipping before ordering.

Replacing Front Turf Tires
Parts and Repair
Replies 2 Post by Bison1

You can get the Tool on Amazon along with the oil plugs below

VW Tiguan Oil Change
Autos SUV Trucks
Replies 3 Post by 42pete

my 3point on my 2260 long trys to lift dose not get far then will not lift at all. have drained oil and cleened strainer and some valves. have not refilled yet . do not no if i need to pull plug under tractor rearend to . or is it filled sepert. the 3 point has ben slow sense i got the tractor a few years ago.this is my first total drain of hydro.

2260 long 3 point dose not work
Long
Replies 4 Post by tinker

[QUOTE=imchrisppy;200971] Nice ! I see you have a vastly superior BALLAST on the rear end, why get loaded tires?Totally flexible just add a cheese burger if you need a little extra. [/QUOTE]

Hahaha, I will tell him when I next see him ;-)

Kubota - New Pix by PhillT
Photos
Replies 3 Post by PhillT

I agree that the Polaris is high on Kool and low on reliable. I like the Honda, Deere and Kubota in that order.

What is the best UTV to buy Polaris or
Utility Vehicles UTV/ATV
Replies 8 Post by gagaid99

I would say Deere Advisor is not great but an improvement over trying to go through a straight troubleshooting process without it.

John Deere Customer Service ADVISOR Review
John Deere Tractors
Replies 2 Post by jmorgan

[QUOTE=Rich1234;200857] Pin on cross shaft for auger is only 5/16 bolt and never broke it.Big thing is don�t push it, once snow starts to build in front, gear down.Have hydraulic adaptation or �abomination�for Shute.If using the wire crank be sure to use more than minimum turns and leave done slack. Shute likes to wobble around to work right. Check bearings on box. Bit of slop ok but likely the retainers as are just pressed steel. [/QUOTE]

Ah I have been lazy and still have a shear pin to replace on my snowblower, like to put it away ready for next year. Never erver thought about using a rgular 5/16 bolt instead of a shear pin. I hate breaking them but too chicken to go your route.

McKee Snowblower Chute Operation
Snowblowers / Snow Plows
Replies 25 Post by Fatguys

I noticed at Walmart that the Greeter now is practicing matching receipts to items in the cart as you exit the store. I guess it is in anticipation of customers self checking out bagless in their cart. Sounds like a night mare. Thinkin of the long lines at Costco which is bagless. Always thought of a bgged item as proff of purchase of sorts.

No Plastic Bags at the Grocery Store
Everything and Anything
Replies 10 Post by Fatguys

Hogslayer...enjoyed your post greatly.

1948 international Cub 12 volt or 6 volt Positive Ground?
Tractor Projects
Replies 6 Post by kthompson

The best thing to do is mechanically controls. The other alternative is too determine which ports do what , make a manifold & run lines to regular hydraulic control valve

shibaura hydraulic three-point lift system
Shibaura
Replies 5 Post by lsheaffer

I can supply manuals.

Hinomoto E204 Owners and Parts Manual
Hinomoto
Replies 3 Post by lsheaffer

I wonder if it has air in it. Running out of fluid shouldn't hurt thr seals.

Belarus Hydraulic Problem
Belarus
Replies 20 Post by lsheaffer

It should be relatively easy to find a 16 inch truck rim to match the original specs.

Look at my pictures.... the green tractors have correctly sized (to match the 4wd specs) radial mud/snow truck tires. They are light years ahead of any bias ply tractor turf tire.

I can help you figure out how to get the ratios correct between front and rear.

Replacement wheel for Cub Cadet 7234
Cub Cadet
Replies 8 Post by DRankin

If you were at good at this it is probably better to just pull it off and start over.

But that said you may as well start with a repair attempt to see how that goes first and use the tear off as your fall back.

The mud probably got squeezed out too thin during application or was the wrong mud type. I would use the green can that has mud with more adhesive in it to set the tape.

I would star by using a 4" knife and gently lift out the loose side of the tape, make sure you get nay dust out, maybe vacuum it as you lisft the tape.

You should gently lift the edge of the tape and get new mud behind the tape, then press the tape flat, squeezing out the excess. A round paint brush might help .

Work the mud behind the tape while squeezing the mud in the direction where the tape was still stuck and you couldn't get behind it. Be gentle with your squeeze-out.
Do a second coat to hide the tape. Maybe a third for finish depending on how good you are. You are just trying to get a flat surface that hides the tape and feathers into the drywall surface.

If all fails you will be stuck replacing entire sections as I doubt that tape you buy today will match the Strait Flex variant from 20 plus years ago.

Have fun or hire it out. Amazing how fast a rpo is at this kind of stuff and how painful for a novice !!

Strait Flex Corner Sheetrock coffered ceilings Repair
Home Improvement
Replies 3 Post by GCGRIMES

Hi, I am new here and found this forum by searching the web for info on logging winches. Read, Farmi vs. Fransgard and was also wondering if anyone had experience with Wallenstein or Hudson. <br>
<br>
As for size, I have an IH 584, 70Hp. My land is hilly and often wet. I would be pulling uphill in places. In some places, moving really big logs (the White ash is dying), <br>
<br>
What recommendation for size would you have?<br>

Logging winches match to tractor brands
Operating and Attachments
Replies 7 Post by Burrobabe