Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

New to site . I am finding the threads to be very helpfull. Great to see member photos as well.

Thanks for all the Great Tractor Info
Photos
Replies 1 Post by blogergoods

I suspect there IS a leak, you're just not looking in the right place.

The MF's run a similar system to the older Ford systems, it uses a completely segregated system with it's own separated reservoir and pump.

The most common problem is a seal in the steering column, the fluid leaks out there and drips off the bottom of the transmission. Because of where the leak is the fluid only escapes under a combination of rev's (higher volume) and steering action.

Best of luck.

MF 231 power steering ghost leak
Massey Ferguson Tractors
Replies 5 Post by Murf

Did you get your drive shaft fixed?

I know it has been a while since your last post but wondering here, what the odds are of finding a suitable shaft or having one made that would slide together for replacment.

Then cut the old into to remove.

2005 Cub Cadet 6284 Drive Shaft Vibration Fix
Cub Cadet
Replies 12 Post by kthompson

Tried posting a wiring diagram hope it shows up

Cub Cadet 7260
Parts and Repair
Replies 4 Post by tipoblanco

Should be able to separate the noise little to what gear?

Kubota M8540 12 speed trans
Parts and Repair
Replies 4 Post by Art White

I would replace trans filter and oil to start, when you check the fluid have everything in the neutral position

TC40D wants to keep moving
Parts and Repair
Replies 11 Post by dualhvision

This is a great thread you should read about farming 20 acres where Ken Thompson posted some very helpful info along with Hardwood.

John Deere vs Kubota or other sub Compact ?
Operating and Attachments
Replies 7 Post by DennisCTB

I checked the sensor wiring etc., it seems to be good. Checked oil pressure manually, all OK. Approximately 10psi per 1000rpm.

I don't think I need to worry too much, although I might install a permanent gauge.

Thanks for your help,

Rob

Kubota L3410D low oil pressure warning
Kubota Tractors
Replies 3 Post by robferry

Hei, tervetuloa! Et sano, mit� osia tarvitset, mutta alueellasi mielest�ni Meka- Laite Oy Hydraulic on paras.

Hydraulic components
Parts and Repair
Replies 4 Post by Murf

Poor farmers fertilizer! Been said many times! On another note every time you leave the grass clippings on your lawn is a 7% boost in nitrogen!

Snow can be good for your Lawn
Garden and Landscape
Replies 4 Post by Art White

I can only Chuckle!!! Good wives don't say no!

Question for all Men
Just For Fun Off Topic
Replies 3 Post by Art White

Despite my recent WIFE humor posts I do live with a lovely gal.<br>
<br>
Hope you and yours have a grand Christmas !

Merry Christmas to all TP Members
Just For Fun Off Topic
Replies 35 Post by chuckles

Great video for replacing the front axle seals on a Kubota B7500.<br>
<br>
[yt]1Bif5tAysWU[/yt]

Replacing Front Axle Seals Kubota B7500
Kubota Tractors
Replies 6 Post by DennisCTB

If it is a remote valve, I.E. there is 2 large cables that run between the joystick and the valve block, you could have a broken wire or disconnected linkage at the valve. Everything would look normal from the joystick end.

See if you can see motion at the valve itself when you move the joystick with the engne OFF of course.

If all of that checks out the other likely cause could be a partially disconnected quick-disconnect fitting in that circuit.

Best of luck.

Cub Cadet 7305 Cannot Lower 417 Loader
Cub Cadet
Replies 6 Post by Murf

[Moderator edit of duplicate Post by Sreebb]

Any other Cub Cadet 7305 Owners with glow plug issues?

[/Moderator Edit]

Cub Cadet 7305 - do I even need glow plugs
Cub Cadet
Replies 5 Post by sreebb

Repairs to both were performed at the same independent shop. Cost drivers on the Subaru were timing belt replacements and brake issues. Also had to do head gasket, which lead to machining head and "while you are right there" valves & guides at about the 150K mark. On average, parts cost were comparable item for item, but the MB needed fewer of them. Needless to say that the ride in the MB was awesome, the electronics and related technologies were light years ahead. In spite of being "loaded" with options, the Sube was only one step up from an econobox; marginally quieter than than my '58 VW Beetle.

2014 Subaru XV Crosstrek vs CRV and RAV4 Review
Autos SUV Trucks
Replies 19 Post by jaoneill

Have you got an update on the stuck engine? If you removed the rod caps and where able to move the pistons then that eliminates them. have the clutch engaged and then try to bar the flywheel, that will rule out anything after the engine. If it is still stuck then the problem would be in the front of the engine, gears there drive the cam, fuel pump and counter shaft. Let us know what you find!

572 Belarus 1988 engine stuck pistons mobile
Belarus
Replies 3 Post by cowrider

Here are some manuals for the tractor. The wire diagrams are not the best but the manuals should help with other problems.

https://www.mediafire.com/?9nutl8b1f6m4jy9 Belarus T25A Repair Manual.pdf - 467 mb

http://www.mediafire.com/?9fylzh952p0ih8u Belarus T25A OM.pdf - 192 mb

https://www.mediafire.com/?8qlp9b2ebp1nxz6 Belarus 250A parts manual.rar - 110.2 Mb

Ignition switch wiring 250AS
Belarus
Replies 4 Post by cowrider

...you have a very nice little TLB

BX23S - New Pix by lariewilson
Photos
Replies 2 Post by charlieK

You can thread the chopping head with 7/16-20 tap and run a7/16-20 bolt to jack it out.

Duerr hp 678 Chipper replacement blades
Operating and Attachments
Replies 86 Post by Danpham2001