Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

If its like mine , its to preheat the glowplugs

Instrument Panel
Mitsubishi
Replies 2 Post by fellerbass

Hi Roger, can you please tell me what battery you are using in the 165d? I have the standard garden mower battery and its shot after not using it all of last year. Have to buy a new battery anyway so I'd like to upgrade it if at all possible. I read on one of your posts that you recommend that and the block heater which it already has.

thanks again!

Yanmar YM 165D implements
Operating and Attachments
Replies 7 Post by thegogetter

If you watch CNBC and MSBC I was watching on PS Vue and YouTube TV simultaneously. PS Vue on TV and YT on Phone.

1) PS Vue is on about a 30 second delay from real time

2) On CNBC on YouTube TV You get the already mentioned COMMERCIAL BREAK IN PROGRESS screen with the MIND NUMBING BIPOLAR MUSIC. But it is worth noting on PS Vue while you have the 30 sec lag, most of the ads display with the stock ticker still on screen whereas on YouTube you get COMMERCIAL BREAK IN PROGRESS. If you are into CNBC and watching the Market this makes the YT version not viable in my view.

Another note if you want to flip between CBS and MSBC back and forth on PS Vue on Fire TV this is easy on Youtube it is a nightmare. Think flipping between the Giants and the Patriot games during any of the games this fall.

And another comment you cannot tell what content you already watched on Youtube TV. While PS Vue sorta covers watched and unwatched, I have found that PS Vue is very inconsistent on this feature.

One very cool thing that Google has put in that is LACKING in PS Vue is an easy FEEDBACK loop for customers to let Goolgle know what they do not like and like.

PS Vue Mobile App vs Youtube TV Phone App
Everything and Anything
Replies 2 Post by DennisCTB

These filters are what i run on my SD 1603.<br>
From O'Reilly:<br>
<br>
Oil- had a Fram ph8, Now has Wix #51515<br>
<br>
Fuel- had none, Now has Wix #33507<br>
<br>
Thermostat- had none, Now has Murry #3058 180deg. (bought gasket mat.)<br>
<br>
From NAPA:<br>
<br>
Radiator Cap- 13lb.psi. # 703-1697 Balkamp brand(USA)<br>
<br>
Fluids:<br>
<br>
Engine= 15w40 Rotella <br>
Hyd.= JD type 303 (from Atwoods Farm Supply)<br>
<br>

SD 1603 filters
Shibaura
Replies 2 Post by shovelhead

I have a 1992 Belarus 825 tractor. I was going just fine and then all of a sudden it just won't move when in gear.<br>
<br>
I checked the clutch adjustment and can see it is working as expected, but am at a loss as to what to try next.<br>
<br>
Anyone experienced this type of behavior before with a Belarus 825, or any other model tractor?<br>
<br>
It goes into gear from what I can tell, just wont move forward or reverse at all :(

Belarus 825 Wont Move When In Gear
Belarus
Replies 3 Post by MontanaMan

I have a 1992 Belarus 825 tractor. I was going just fine and then all of a sudden it just won't move when in gear.<br>
<br>
I checked the clutch adjustment and can see it is working as expected, but am at a loss as to what to try next.<br>
<br>
Anyone experienced this type of behavior before with a Belarus 825, or any other model tractor?<br>
<br>
It goes into gear from what I can tell, just wont move forward or reverse at all :(

Belarus 825 Wont Move When In Gear
Belarus
Replies 4 Post by MontanaMan

Hey guys. I'm new here but am frequently on other forums. We have a Gator 6x4 gas and when you start driving it will pop out of forward or reverse and go into Neutral on its own. You can hear it grinding when it pops out and is close to meshing. This problem started out in reverse only and now has begun doing it in forward gear. It will not do it if you apply pressure with your hand on the shifter and hold it in gear. <br>
<br>
Is this something internally that is broken/worn and needs repair, or is this an adjustment ? I plan on repairing it myself or taking to the JD Dealership. <br>
<br>
PLEASE HELP!

2004 Gator 6x4 Gas Pops Out of FandR Gear
Utility Vehicles UTV/ATV
Replies 2 Post by ALFarmallBoy

Dennis CTB- Thanks for the link! I will get right into it. Again, thanks! - texgyrene

Air in 2003 New Holland TN75D Hydraulic system
New Holland Tractors
Replies 5 Post by texgyrene

Radiator has to be hot for the fan to work. You need to bleed the air out of the system. Bleeder screw is beside the 90 degree carb neck. open the screw and fill the radiator until fluid comes out. When full, tighten screw and continue filling radiator. If the radiator is full and there is nothing coming out of the hole, you will have to fill the hole with fluid yourself. Radiator should get hot in a few minutes, if it doesn't, check the bleeder again and fill. Keep doing until radiator gets warm...........

Gator 6x4 Overheating problem
Utility Vehicles UTV/ATV
Replies 13 Post by gatoraider

I am hoping that you were not pinned or injured in the process. That said, the B7100 was/is rather a simple designed tractor. Two things come to mind - First, and the easiest to check, is to make sure that all of the linkage is still intact. Too often, the ring pin locks, or pull pins will rust and ultimately break off. Then when you least expect it, the linkage will fall off and become disengaged. This might have happened as this is an older tractor. It might just have fallen off the lever pins. Check this first.

Second, it is possible, albeit a breathing system, to develop an air block in the hydraulic circuit. This would most likely be evident in the filter for the drive. Take the cover off of the HST housing where the filter is located. Open up the fill cap on the tranny housing (just unscrews). Place matting or rags under the tractor, and remove the filter. Have a new filter ready to replace. I usually "charge" my filters before installing, to prevent an air block. To charge the filter, merely pour clean HST oil in the filter, and allow to stand for half hour or so, to allow it to soak in.
Then reinstall the new charged filter onto the tractor. Start it, run it and check your fluid levels. Make sure not to over fill if needed.
This should take care of any air blockage that could have developed.

Good Luck - Hope this helps,

Willie H.

Kubota B7100 HST Flipped Will Not Move
Kubota Tractors
Replies 2 Post by WillieH

I flipped my kubota on it's side <br>
After letting it sit for 2 weeks it did start and run and hydraulics work raising and lowering the bucket and tiller but the hydro static transmission will not move the tractor forward or backwards

Kubota b7100-hst
Kubota Tractors
Replies 2 Post by Deseay

Does anyone know what a mitsubishi 2350 tractor with a loader would weight?

mitsubishi 2350
Mitsubishi
Replies 3 Post by bigdaddygb

I have also had intermittent starting and power loss with fuel tank problems. The fuel pick up tube inside of the fuel tank can be blocked. It sometimes allows fuel to flow but when under load or plugging intermittently can happen and the tractor will not start or perform 100 %. We have had this happen on a 100 horse John Deere......We call it getting the bugs out cause it was from a tractor that was soled probably for the same reasons. The vent line and the the tank were filled with earwigs... So they would pump up allow some fuel but at times block the fuel....

Engine won t fire on JD 770
John Deere Tractors
Replies 6 Post by mnavojos

4690 Backhoe will fit but you will need to get mounting plates from dealer if the one you have does not have them. You can also look for an aftermarket such as woods. I would never just use a 3pt backhoe attachment on a tractor. I would also never put a backhoe on a tractor without a front end loader. ...Good luck

B2150 Backhoe attachment
Kubota Tractors
Replies 4 Post by mnavojos

Thanks! I have not worked on it for a couple of weeks but have the injectors out,,

Where to have Yanmar Injectors cleanedchecked
Utility Vehicles UTV/ATV
Replies 5 Post by pposey

My prvt messg is not working or it is do to operator error.... any how MF205-4 serial # 00694, that should make it a '81..? my previous reply to this thread has the pick of my damaged parts. Let me know if there is any other info you need. via my direct Hotmail account or pvtmessg here)
ps: I am getting prvtmessg email notification's
Thanks much
Arlen

MF205-4 anyone
Massey Ferguson Tractors
Replies 11 Post by cansox12

I would like a breakdown of this. And a rebuild kit. I am also needing a new washable screen, that one is full of holes!

Anyone have any info on this tractor
Jinma Farmpro Agracat Nortrac
Replies 8 Post by Chaos921

Chaos921 has posted a new photo.

Subject: Allied.

Description: <br>Allied tractor

Allied - New Pix by Chaos921
Photos
Replies 1 Post by Chaos921

Update: Mower starts perfectly on first crank every time now.
I think when I discovered that seemingly insignificant leak while pumping with the bulb, I found the source of the problem. The leak was a very small hose crack at fitting coming of filter to injection pump.

Yanmar Fuel pump or primer bulb
Parts and Repair
Replies 8 Post by Coachlarry

Electric over Hyd p21f
Shibaura
Replies 4 Post by shovelhead