Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

It all depends. If you think you might eventually want to remove the pole barn, concrete will not be your best choice.

Otherwise gravel can be a real hassle in so many ways, just drop a nut or washer on gravel and try to find it! Ans as posted jacking anything up to work on is unsafe.

So if is just the cost, concrete is worth it as long as you plan on making it permanent.

stone vs concrete floors
Barns Pole Barns
Replies 6 Post by minimac

I'm in central NY where we get over 100 inches a year on the lighter years which may sound like a lot but it normally might only be a inch or two a day or maybe five or six and some times over night. You are 800 ft long and how wide? To be 10 ft wide you would be spotless with a 55 or 60 inch with two trips out to the end. That covers for a BX, is your driveway paved or dirt? To have a paved driveway it very well would have no build-up and no chains of any sort are needed.

Size Kubota for Homeowner Use
Kubota Tractors
Replies 7 Post by Art White

I have a John Deere Gator 4 x 2 that has been well maintained, (garage and trailer kept) I started it this morning upon arriving at the 'job site' and it expelled thick white smoke for several minutes as well as oil through the exhaust. It left stains in the trailer, on the road, as well as in the cemetery we were working on. After running for a while, it abruptly stopped. No more smoke and no more oil. Does anyone have any idea as to what may have caused this to happen ad should I be concerned? Thank you.

2000 John Deer Gator 4 X2
John Deere Tractors
Replies 3 Post by Moskoman2312

ok anyone in need of DougFeng tractor parts Call Chip 479-705-2200. He has parts. Real nice guy. And Sandy the receptionist is very friendly and has not 1 problem helping also.......

Taskmaster Trooper 426e 4x4 - need parts
Jinma Farmpro Agracat Nortrac
Replies 4 Post by bbqhoncho

I've been using Rotella T6 5w-40 synthetic. I'll let you know if I figure it out.

LB1914 Low oil pressure
Kioti Tractors
Replies 12 Post by Chazster3

Most are available from your dealer. There is not enough demand for the after-market.

I need some OEM Quality decals for a B7500 DT-TLB
Kubota Tractors
Replies 2 Post by Art White

Where do I hook up the mechanical Guage on my Kioti ck25? My oil pressure light comes on and stays on for 45 seconds after start up. Seems like maybe a sticky pressure valve.

Low oil pressure on my KIOTI CK25
Kioti Tractors
Replies 1 Post by Chazster3

Where do I hook up the mechanical Guage on my Kioti ck25? My oil pressure light comes on and stays on for 45 seconds after start up. Seems like maybe a sticky pressure valve.

Low oil pressure on my KIOTI CK25
Kioti Tractors
Replies 1 Post by Chazster3

Glad to assist, and, that the orange is cooperating once again!

Best -

Willie H.

Hydraulic oil in crankcase
Kubota Tractors
Replies 4 Post by WillieH

if anyone can help me out on this tractor and you like to hunt i can put you in a deer stand on my property there are some 180 to 200 class bucks here, can,t guarantee you will get one but they are here i live in southern ohio.

LONG 530DTC
Long
Replies 5 Post by WALKER47

my dealer closed without notice. Please who sells parts for DongFeng task master trooper 426E 4X4... I'm waiting for a call back from a Gent in Texas. But askin in case of no luck.. I do know they are still manufactured

parts dougfeng task master trooper 426E 4X4
Other Tractor Brands
Replies 1 Post by bbqhoncho

my dealer closed without notice. Please who sells parts for DongFeng task master trooper 426E 4X4... I'm waiting for a call back from a Gent in Texas. But askin in case of no luck.. I do know they are still manufactured

parts dougfeng task master trooper 426E 4X4
Other Tractor Brands
Replies 1 Post by bbqhoncho

I Google my tractor name and found you Kids, Y'all seem to know quite a bit of info. so I'm asking for your help....<br>
<br>
on the left front there is what I'll call a steering knuckle.<br>
It rest on a pivot point on top of the left steer wheel. It then connects to the rack n pinon. the drag link it bolted to the bottom of both steer wheels.<br>
Well it's broke tried to weld it because my dealer closed with out notice. That failed(didn't think it would work) I have no idea where to purchase parts. oil filters, air filters, and other parts. Like my steering knuckle..... <br>
<br>
Thanks Kids, bbqhoncho

parts dougfeng task master trooper 426E 4X4
Jinma Farmpro Agracat Nortrac
Replies 1 Post by bbqhoncho

I'm unsure of there being a oil cooler used but with larger tractors that is a common failure. Other wise your oil system runs with more pressure then the cooling so you do have a leak!

Kioti LB1914 oil in radiator
Kioti Tractors
Replies 2 Post by Art White

Motor grader is used very often in the road building and leveling. It is troublesome when the machine breaks down during the working process under a tight working schedule. In case of emergency, construction equipment daily maintenance is very important to keep the machine in a good condition all the time. The followings are some guidelines about the road machinery daily maintenance.<br>
<br>
Engine is the heart of the construction equipment, the machine will stop working if the heart goes wrong, more attention should be paid to the engine. Before starting the engine, we should check the fuel level to make sure the machine can operate normally. What is should be noticed is that the fuel should not be filled too full since fire will be caused if the fuel overflows under high temperature. Check the fuel pipe and fuel tank to avoid any leakage. And the remaining water and other sediment should be discharged every day to keep the fuel tank clean and purified. The coolant should be added enough to keep the machine work normally. The radiator should be checked regularly to keep the machine cool and the damaged radiator should be changed immediately to keep the machine operate smoothly.<br>
<br>
If only you master the above maintenance guidelines, your motor grader will operate in high efficiency and create more profits for you.<br>

Grader Motor Daily Maintenance
Other Tractor Brands
Replies 1 Post by validation

Could you send me more info on the bolt pattern so I can get the right wheels.

Front wheels for a John Deere 1050
John Deere Tractors
Replies 11 Post by jdb0125

Thank You all so much for the info on my Shibuara

I am wondering if you can tell me where to find the drain plugs for oil, I think it is the first nut under the steering wheel, on the bottom of the body

the Hydraulic fluid for the PTO has me confused
I think the dip stick is behind the seat and i think the PTO drain plug is underneath the seat under the tractor

what hydraulic fluid is best and how much do i need
my brush hog fades down when i am mowing, and starts plowing dirt! not good!
i think i need to try changing the oil and hope that fixes that problem. fingers crossed

i have another question....do diesel engines have spark plugs? I see three metal wires connecting to the engine with big nuts that seem to have spark plug type things, and I see a little box off the engine a bit on the right side that seem to have more normal looking spark plugsspark plugs, three in a row

I have heard talk of "glow plugs" on old diesel trucks, i am wondering if the odd looking things on the engine are actually those...they look a little like spark plugs, but not as much as the three in the "box"

thanks in advance
all of you are great!

so glad to find this web-site

SD2203 Shibuara
Shibaura
Replies 7 Post by Cherix62

Do any other hydraulics work? Steering or scv? I assume you have independent loader control valve? I would start by changing the hydraulic filter, draining hydraulic fluid and cleaning the screen. You also could have a bad stroke control valve in the pump. Answer back with more info and we'll see where to go next.

JD 72 1520 Hydraulics
Antique Tractors
Replies 2 Post by jdgreen

I would have to agree with first post. if you have not voltage at small post with start button pushed check is you have a broke wire at your clutch safety switch.

Nortrac 254 will not start
Jinma Farmpro Agracat Nortrac
Replies 3 Post by aceme2

I don't know if you still have ur problem but if so it sure sounds like the loader valve on the pump. Don't know what running out of gas has to do with it but I've fixed a few with the same symptoms and it was always the loader valve. Try starting it with the trigger on the wand engaged.

Honda Gx270 Will not start Stumped
Shop Tools
Replies 13 Post by Evelhorn