Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Great, was there much oil in the cylinders? Hope it works out for you.

Jimna 284 Engine Knocking and leaking oil after Tipping Tractor
Jinma Farmpro Agracat Nortrac
Replies 4 Post by greyhorse

Thats what i'm thinking but the dash lights are confusing me. Why would the alt light come on when switched to off and then when switched back to run position the glow plug light comes on. Do you think that the solenoid being stuck open might cause that? Thanks for you input

New Holland TC35 Tractor will not turn off
New Holland Tractors
Replies 4 Post by unitedcs

I also agree the manuals are great to show different setting on the tires.Call your Kubota dealer and they should be able to help you also.If you cannot change setting,call Motorsports Tech, they will make spacers for your Kubota.

How widen rear wheels on Kubota L4330 HSTC
Kubota Tractors
Replies 6 Post by blacksheep

I am needing a Cub-Cadet-Model-445-Auxiliary-Valve-Kit<br>
<br>
If you have one to sell please contact me.<br>
<br>
1-270-828-2004<br>
<br>
<br>
Thanks<br>
<br>
otis

Cub-Cadet-Model-445-Auxiliary-Valve-Kit
Cub Cadet
Replies 1 Post by kysales

I assume it comes back on after a few minutes and does the cycle over and over? If so has to be something over heating that is having to cool, if you have a breaker in that circuit and not a fuse it could be that breaker or something in the circuit. But if fused which most likely it is than the fuse would be blowing if overloaded so assuming it is not over loaded.<br>
<br>
My thoughts are you will find the issue in the floodlight itself. If the switch on the flood light it might be that but it also could be the bulb. If there is no switch on the light itself would replace the bulb. kt<br>
<br>
<br>
Be sure you check the ground where grounded to the tractor.

Flood lights go Off on John Deere 4040 Tractor
John Deere Tractors
Replies 3 Post by kthompson

Unless you know something is terribly wrong with the Hoe I would just let it all mix together as it will and then change all the fluids to whatever your tractor runs on when you want to.

3PH Backhoe Flushing Lines and Cylinders
Loaders Back Hoes
Replies 5 Post by joyce1

Look for bent or stuck linkage.

Mitsubishi Tractor Transmission will not shift out of High Range
Mitsubishi
Replies 5 Post by greyhorse

Your tractor should use the model M03270X blade. <br>
<br>
If you have never used a blade on a Garden Tractor before make sure you have chains. <br>
<br>
One of the temptations with this set up is to ram the snow at speed to compensate for the lack of weight and traction with snow that is too deep for this size machine. I have done that for years and it does wonders for back pain. After 10 years of doing that I finally got a snowblower which is really is the best thing for at Garden Tractor, absolutely 10 times better than a blade.<br>
<br>
Also to use a blade on a Garden Tractor you will be wanting a pretty flat place to use it. It can work on grades to some extent but you have to make many trips during a storm because too much snow depth tips the traction equation against you :(<br>
<br>
Have fun!<br>
<br>
<br>
<br>

John Deere GT 262 and M03481 48 Front Plow
Garden Tractors
Replies 3 Post by bobhope

I don't think so but am no authority. 800 lbs difference in these tractors plus width difference. Even if the loader is wide enough to span the frame I believe the mounding hardware would be much difference. To get a definite good answer try contacting http://www.coldwatertractors.com/loaders.html They manufacture loaders for the Yanmars so would know for a fact.

Yanmar 2200 Tractor Loader fit Yanmar 336D Tractor
Yanmar Tractors
Replies 3 Post by winston1

Now, three days later, I start the tractor and drive it back to storage shed. Discovered dipstick not touching fluid in reservoir behind shifter. What kind of fluid goes in there?

Hinomoto E1804 Tractor Drive Failure
Hinomoto
Replies 2 Post by markaw

[QUOTE=kvinodkumar;191350] Has Category 1 been hitch-hiked to handle power shaft specs between the tractor and the attachment?cheersk vinod kumar [/QUOTE]<br>
<br>
I think it just means that it is a Narrow tractor and may not be able to take standard width Category 1 implements.

Tractor Category 1 2 3 Hitch sizes Defined
Operating and Attachments
Replies 20 Post by DennisCTB

I have a Kubota B7610 Tractor and have only done regular maintenance in the 10 years I have had it. B7500 and B7610 are very much the same as to size.

Neither of these machines have draft control on the 3PH if that matters to you.

Kubota B7500 Tractor Buying Advice
Kubota Tractors
Replies 6 Post by DennisCTB

i looked back and couldnt find the pictures u talked about, what i did do was to loosen the hydralic in going to the block beside the lift lower lever with the tractor running to see if it had pressure. when i loosened the bolt fluid did come out but not like the high pressure u would think, maybe i just think it should be more thank u

Nortrac NT204C Tractor 3PH does not lift
Jinma Farmpro Agracat Nortrac
Replies 15 Post by cdjordan

OK, but not sure when that will be. My heated garage isn't available to work in this winter. The hoe is still on the trailer as I have to bring the Foton with the loader home from the lake property to be able to lift it off.

Rigid Toplink for 3 point hitch Backhoe
Loaders Back Hoes
Replies 17 Post by yocsr1

Did you resolve the issue with your Ford 1000? Could be several issues simplest would be gaskets.

Ford 1000 blows oil in exhaust stack
Antique Tractors
Replies 3 Post by greyhorse

many thanks. That gives more comfort in purchasing this tractor.

Farmtrac 555 Tractor Review and Advice
Other Tractor Brands
Replies 4 Post by oldnintheway

Trying to find a replacement electric clutch for my little Ford 4wd w/front mount Ford 715A snowblower. Where to look? Thanks,Tom

Ford 1210 Snowblower parts
Other Tractor Brands
Replies 1 Post by tjm1952

I have a e-394 4x4 w/fel I just bought the l/f axle housing bearing was bad well it trashed the housing I have burned up the internet looking for a housing tried to get it repaired but its to far gone..pretty disgusted by now the tractor runs good turbo's good looks good got a small ding on the hood everything works..but I think im going to just sell it for what im in it for gave $3500 for it any takers?? im in n.m.it even has a brand new 6ft boxblade

Hinomoto E-394 project Needs Axle
Hinomoto
Replies 1 Post by rumblebee

anyone know of any current zebra parts dealers? American Jawa is gone. no reply from wisconsin engineering. bummer.

ZETOR ZEBRA 2040 4WD Reviews Buying Info
Articulated Tractors
Replies 104 Post by zetorzip

You need a forward gear and a shift collar in your transaxle. And while you are in there you should do the reverse gear also.

6x4 Gator Utility Vehicle pops out of forward gear
Utility Vehicles UTV/ATV
Replies 2 Post by gatoraider