Tractorpoint Login

Search for =

Topic

Whoever wrote that response to you was probably tired of this nonsense and was pulling your leg. All the landings were on the near side since there was no radio contact on the far side. Our telescopes cannot see objects as small as the moon rover from 250,000 miles away through the distortion of the earths atmosphere. Your friends telescope can see Saturn's rings clearly because they are up to 180,000 *miles* across. The earth isn't even 8,000 miles in diameter and the Lunar rover is what, 12 feet long? The rings are made up of individual chunks of debris, some of it 10 feet or more in diameter. Can you see the individual chunks of debris in the telescope? Have you ever seen a big moon rock in any of the telescopic images from the moon? I'm sure not.<br>
<br>
I've seen rebuttals to all the evidence that says we never landed, and the rebuttals are pretty clear. Any conspiracy that widespread would have been revealed by now. Think about it - tens of thousands of engineers worked on that project. And nobody talked?<br>
<br>
If we had not landed I'm sure that other countries (like the USSR) would have been first to label it a fraud. They were tracking Apollo the entire time.<br>
<br>
But the most convincing evidence that we DID land is the fact that the first landing placed a reflector on the moon. A laser is aimed at that reflector from the earth and has used to measure the changes in the distance between earth and moon ever since. The laser is fired from an observatory in Flagstaff (IIRC) that is staffed by civilian scientists. They all seem to think there's a reflector there.

We never went to the moon or did we
Just For Fun Off Topic
Replies 12 Post by kwschumm

Found the condenser dirty i have been washing it off but did not remove the screen in front of it. After cleaning it the head psi came down to around 200 at 78 degrees outside and the inside temp at vent was at 41 to 45 degrees. I think it will work much better now. I will give it a try tomorrow. Thanks for all the help.

Jack

John Deere 3520 Air Cond does not work
John Deere Tractors
Replies 17 Post by whiteturbo

$Dieseltech, Rather than torch the pulleys off, put a little heat to the area surrounding the shaft, then tap the pulley with a light hammer several times. This is usually enough to break them loose. A little heat applied to the pulley will cause it to expand just a fraction of inch, allowing it to break free from the shaft. If that doesn't work, you can place a heavy bar of steel against the pulley and then hit that hunk of steel with an air chisel. The rapid vibrations will usually break the pulley loose from the shaft. You should then be able to remove the pulley with a puller. Don't torch the pulley. It'll come off with a little heat and vibration applied. Joel$ Ford 930A Gearbox
Mowers Field and Finish
Replies 3 Post by candoarms