Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

It is certainly a change from the old tractors like Olivers that you could pull the back fenders and plow the field with it.

Like the early seventies bumpers. We restored a Datsun 1200 once, I pulled the fount bumper and it was like tin foil without the braces on it. I was suprised they could chrome metal that thin.

Earthwrks, a little more chrome and some fake fur, we could enter it into "Pimp My Ride" on MTV.

difference TC 30 or TC 29
New Holland Tractors
Replies 19 Post by Peters

Been there, done that.

I think this is where the expression, "Can't see the forest for the trees" came from.

Fixin Something That Aint Broke
Just For Fun Off Topic
Replies 2 Post by DRankin

You didn't say if your CUT is a 4x, but you can't mix tire sizes that do not meet factory specs---just like on a 4x4 truck. On my bobcat I have 12-16.5 tires--however the actual sizes on both the width and height of the tires can vary as much as nearly 2" which will cause drivetrain bind-up and an unlevel condition.

I'd check with your 'bota dealer and ask them if they have any take-offs that somebody made a deal on when they bought a new CUT.

L2850 Tires
Kubota Tractors
Replies 8 Post by earthwrks

I keep a 6x6 patch of flannel rag for rotating the spline. There shouldn't be gobs of grease on your spline. Only enough to keep it lubed.

Trouble attaching PTO driveline
Kubota Tractors
Replies 14 Post by ditto95

Hello Tractor Guys & Gals!<br>
<br>
I'm looking for a salvaged Kubota L225DT (4WD) - Specifically need front end parts (differential) - <br>
(Front Differential Case assembly part number 34219-43300)<br>
<br>
Several sites show this part number but when I call it's not available -- <br>
<br>
I've already tried West KY Tractor to no avail....<br>
<br>
Thanks, Richard<br>
<br>
<br>
<br>

Kubota L225DT parts
Kubota Tractors
Replies 1 Post by rlray71957

Thanks KT,
Have tried changing while there is a slight movement forward and the lever moves freely now, thanks for all the help / ideas.

Mike

Trouble switching between 2WD and 4WD
Jinma Farmpro Agracat Nortrac
Replies 6 Post by locksleyred

i need a muffler for satoh s370d,would pefer new,only found 2 used on internet,any one know where to get parts?<br>
thanks

muffler for s370d
Mitsubishi
Replies 2 Post by tb2942

Have you checked the fuel filler cap (the ventinf portion of it) to be sure there isn't a vacuum condition? A samll amount of dust and debris mixed with with fuel is all it takes.

Engine dies after warm up
Mitsubishi
Replies 4 Post by earthwrks

If you have it torn down that far I would replace the bearings. With out seeing first hand it is hard to tell. Can you e-mail pictures of the damage.

WILL NOT START
Yanmar Tractors
Replies 9 Post by oneace

She can only be cloned. Breeding was taken away from her as a pup.

The Lab Manure Roll
Everything and Anything
Replies 40 Post by oneace

If you are interesed, I have 2 sets of the original Ford 801 hood Decals. $30. plus shipping-about $6.00.
Thanks,
Ron Drake

Decal set for 801 ford
Antique Tractors
Replies 7 Post by RonDrake

PEX Good Stuff. I went to e-bay and bought the 1/2 and 3/4
crimping tools, Got them new for half what Lowes wanted for them., Simple to use not near as high as copper,. Sell copper,Buy Pex, Take wife out to east with whats left over couple times.

Pex vs Copper replace Copper Pin holes
Home Improvement
Replies 17 Post by RRagent

Thanks Ken, all's good in my neck of the wood.

Happy Father's day to all and the most thanks to our Father in heaven.

The end of horse_farmer
Website Operations Howto
Replies 34 Post by DenisS

dk, we've had really good luck with Bayer products, it turns out they can cure headaches in turf as well!! LOL.

They have a new product out the last few years which is a broad spectrum fungicide, that is it acts on nearly any fungus you are likely to encounter in your lawn, the most common being things like dollar spot, brown patch and rust.

It is marketed under the name Armada� by Bayer and is really just a combination of two of their best (IMHO) sellers, Compass and Bayleton which have been around for years. It is approved for the 14 most common turf funguses.

You should be able to get it at any farm supply, TSC, Co-Op or that type of store.

As for the wind, all we do is wait for a calm night without too much dew then apply it at right at, or as close to dawn as possible. You will generally have more than enough time before the breeze picks up. If this is not possible you can lower the nozzle, reduce the flow, and travel a little faster and still apply in a breeze, just be sure to stay downwind of anything you don't want sprayed.

Best of luck.

Sprayer for ATV
Utility Vehicles UTV/ATV
Replies 18 Post by Murf

I asked my shop yesterday on this and they said that engine runs about 205 to 210. It could be your thermostat is stuck open, or missing. Is it possible the sending unit is not a match for you new guage or it is bad. I would think you had run it sufficient to see it reach it's normal operating temp.

MF 253 info ASAP
Massey Ferguson Tractors
Replies 8 Post by kthompson

need to know torque for heads and rods

engine torque for a 1500
Yanmar Tractors
Replies 1 Post by cpdtwo

My 4310 has been very reliable. It's the same machine with a little bigger engine. Weak points? Open the hood and look for corrosion around the battery, radiator and oil cooler where battery outgassing occurs. The 4210 is sometimes considered a little underpowered for it's frame size but it can do a lot of work.

thinking of buying a 4210
John Deere Tractors
Replies 6 Post by kwschumm

Me thinks someone might be getting the shaft. I would have thought the new driller would have a drill rate w/o casing and your original driller who hired him should have a rate.

I'm not in the lets put in new casing at this point. Me thinks I would start gluing plastic PVC as large as I could get down the original casing, to the bottom of the new dig. I'd drill lots of holes in it. Hack a big slot in the side of it for the pittless connector and put the pump 10' from the bottom.

The new drillers address is not at the cornner of "RIPEMOFF ST & GOOD ST" by chance is it?

Well Water Problems
Home Improvement
Replies 37 Post by harvey

Click on my name above Mike, and contact me via email. If the address isn't visible, send me a private message and we'll coordinate offline.

//greg//

Hydro oil frothing out of tank on 3 point b hoe
Jinma Farmpro Agracat Nortrac
Replies 18 Post by greg_g

Thompson: I considered using those plastic visors which are used on school buses also. The problem with my situation is the conditions are extremely dusty and dry so constant cleaning is as issue. The mesh will get susty too but shouldn't be as hard to keep clean.

And I know yer 'razzing me 'bout going in circles, but just for the record they are overlapping circles which an old timer told me how to do when it comes to grading large areas. If you have never tried it, you should.

Truck bed limits
Pickup Trucks and Trailers
Replies 29 Post by earthwrks