Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

My price was $20,300 for the same tractor with loaded rear tires. Sounds like you should be able to do a bit better. So far, I am very happy with my Kioti. It has done everything I have asked it to.

Price on Kioti CK25 or CK30
Kioti Tractors
Replies 15 Post by robtadge

I believe you are correct. The BX rear housing is aluminum.

Is the Kub BX23 Transmission casting aluminum or iron
Kubota Tractors
Replies 9 Post by jarndt

I just bought an '85 john deere 1050 compact tractor w/ 3900+ hours. It's got a model 75 loader. Hydraulics are sluggish and hydraulic/trans oil is grey - apparently water got into the system, though not sure how. At a minimum, I will need to change the filter and oil. <br>
<br>
Is there a liklihood that something else is causing the sluggish behavior (clogged filter, damaged pump or control valve, etc)? Is there a history of water getting into these hydraulic systems?<br>
<br>
Thanks,<br>
Beatford68

jd 1050 hydraulic system
Parts and Repair
Replies 3 Post by beatford68

Pete,

Thanks! I can't wait to take delivery :)

Pricing questions and backhoe questions on Cub 7254
Cub Cadet
Replies 11 Post by brettD

The sound is normal. My TC33D does it when it's 50 degrees and lower out. For the most part (aside from cavitation of really cold fluid) the sound comes from the pump gears chattering against themselves since they are steel (not a problem). As the pump case, which is aluminum, expands due to heat buildup at a higher rate than the steel the gears move away from each other lessening the chatter. Conversely, with these type pumps the hotter they get the more they lose the ability to make pressure---because the gears have moved too far from each other, and the side plates that push against the gear sides have to travel farther to push against the gear sides to retain pressure.

Generally modern oil filters have a bypass built into them or into the base that they screw to. I don't know of any conditions that would cause a pump to lag if the filter is dirty or collapsed. If that were that possible I think you would see filters blowing off engines due to back- pressure.

TC29 hydraulics
New Holland Tractors
Replies 7 Post by earthwrks

New Holland dealers have an "aftermarket" line I believe is called "FleetGard". If it were me, I would spring for the OEM filters which are designed and (I hope) tested for this particular application. All filters are not equal. Plus your dealer is more apt to stand behind you in case of a filter-related problem especially if you bought it from them, which includes oils too. Don't want to drive? Ask them if they get a FedEx or UPS discount that they can pass on to you and see if they can ship it to you. You might be surprised that after it's all said and done---wear-and-tear, your time, gas---that is makes sense to have it shipped to your door.

TC29 hydraulic filter
New Holland Tractors
Replies 3 Post by earthwrks

drbandson: Yep and we can't imagine getting $5 a yard either. Keep in mind these are contracts that have as many as 5 levels of subs subbing the work out. I have loade dumpsters and dump trucks for as little as $2 a yard. We came down here for what we were told was $40 a yard. Dreaming. Many guys have gone home broke, or worse are owed so much money that we will never see (like myself about $3000) that we can't even afford to go home. There is a lot work to do and you'll see guys who spent (or borrowed) their life savings that are selling their equipment on the side of the road.

My dump trailer was made by JDJ. 12,000 GVW rated. It's 6'x10' with 24" sides. I have ramps for it that I made out of a new mobile home trailer tongue I-beam. They're reinforced with 1/2" bar stock to create a truss. Super strong yet relatively light weight. The I-beam shape creates a natural tire guide.

My buddy used it down here in Miss. picking up debris to move his machine from site to site---and pulled 2000 miles with the machine in it. He has steel tracks on his skid steer. Metal against metal the skid steer wouldn't climb the ramps with the dump box in the full-down position. But I raised the front about 18" and it walked right up with little slippage (raising it changed the approach and break-over angle just enough).

There was a post about three-axle trailers. From what the Michigan and Alabama DOT (and Motor Carrier Enforcement) has told me, by law (if even appears that you make ANY money with it) and you have a 3-axle trailer you have to have a CDL. This applies to "landscapers and even weekend warriors race car guys who make even a dollar in winnings---it's then considered 'commercial'" (this was part of conversation I had last Thanksgiving with a nice Alabama DOT officer who issued me tickets for a broken taillite, no medical card, no DOT numbers, no log book, no truck inspection, and no trailer inspection----all with me driving my 2500 Dodge Ram pulling my two-axle equipment trailer with my NH TC33D, an auger for the bobcat, and a walkbehind concrete saw. He was going to detain me for at least 8 hours on the side of the road until I told him I was cleaning up the hurricane---then he said he would let me proceed under the "FEMA Exemption" law---but I had 14 days to comply/fix everything). I'm getting to the point where I hate driving anymore!

dump trailers
Pickup Trucks and Trailers
Replies 14 Post by earthwrks

Yes, I can supply manuals for your tractor as well as any parts you may need. Email or call 1-800-609-5110

mitsubisi kumiai ST1620 3 pt
Mitsubishi
Replies 6 Post by BillRodgers

<br>

TC24DA price and use
New Holland Tractors
Replies 15 Post by zigmondo

this link may help

TC -24 steering
New Holland Tractors
Replies 2 Post by SG8NUC

Getting back to the original subject, I would forward the phishing email from "paypal" to your state's Attorney General's Office. Just because Paypal says they can't locate the originator of the email, doesn't mean it can't be done. Emails leave tracks in Cyberspace, but it can take a lot of effort to track them. Enough complains and someone will pick up the ball and run.

Your Attorney General's office may not be able to find the originator, but they can direct you to where to forward your complaint.

Paypal email scam
Website Operations Howto
Replies 24 Post by kyvette

The 2210 has a connector at the rear of the seat. It can be used to run a set of back-up lights. It is controlled by the light switch on the dash.

My only problem was mating the connector they used. I cut theirs off and installed my own. Look at my pics and you might see a yellow wire cover - that's where the line is.

I recently wanyed power up front fro a sprayer. I could not find a source up under the hood by the lights. I would up drilling a swutch into the dash and running a line up to the battery as you plan to do. It isn't hard, but it is clumsy. An extra socket on the fuse bank would have been helpful.

Berland Meyer

adding a horn and extra lights
John Deere Tractors
Replies 4 Post by bmeyer

Compression (PSI) Standard: 450
Compression Lower Limit: 325

hope this helps

B7100-D750 engine
Kubota Tractors
Replies 2 Post by michaelg

Isn't it amazing what some supposedly intelligent people will fall for on the chance they'll get something for free?

Look at those get rich seminars. The money isn't in the advice but in charging for the seminar.

Total SCAM
Utility Vehicles UTV/ATV
Replies 6 Post by Iowafun

The China Jinma Tractor Horse Power is rated at the PTO, not to the ground.<br>
<br>
I think you would be Ok with a 6 foot Finish mower as long as you don't let the grass grow tall enough to need bush hoging.<br>
<br>
Ronald<br>
Ranch Hand Supply.

What size 3 point finish mower
Jinma Farmpro Agracat Nortrac
Replies 11 Post by RanchHand

To watch e-bay or your local dealers you might find what you need. It normally takes many years to wear out a deck but it does happen and the tractor chassis of the GF is good for a lot of hours but a poor operator may run into enough stuff to kill a deck.

GF 1800 NO DECK WANTED OR SELL 60 DECK
Kubota Tractors
Replies 3 Post by Art White

You have some good dealers that have been in buisness a lot of years in your area. I would wonder why you are stoppng at a 60" deck? You are going to be close to the trac width with the deck. The L-2800 and 3400 would be a good alternative if a rear mower was used and you'd have some extra weight to deal with the larger acreage and projects. The 3400 would take a larger yet three point mower to help cut the mowing time on the 5 acres.

B3030
Kubota Tractors
Replies 9 Post by Art White

ditto, maybe he is talking about the hydraulic operation of how the deck is lifted and lowered?

kubota mowing deck
Kubota Tractors
Replies 3 Post by DennisCTB

Often times the simplist things can cause problems. The problem you have sounds like it might be a loose wire. It could be in a connector that has not shown till now. It could be a weak ground that gets weaker with the mass movement. Anyway you look at it it will be tough to find till it stops completely and then be chased. I wasn't aware that they built a shut off switch for the PTO into the engine temp circuit. That's nice if you do have an over heating problem with them.

1445 mower problems
Garden Tractors
Replies 6 Post by Art White

Peters,
I don't pretend in the least to be an expert on American Indian history, but if your knowledge of Indian history is based on the Indial folklore, rather than on historical and archeological evidence, one may say you only have one half of the story.

Sick and Tired
Everything and Anything
Replies 41 Post by DenisS