Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

The small under counter sinks I installed in the bathroom are basically glue and screw. They have small Hilti type fasteners into the stone with clip that hold he back of the sink, after you glue with RTV the top edge of the bowl.

Under mounted sinks
Home Improvement
Replies 9 Post by Peters

I believe it is a heavy duty top link bracket.

subframe vs 3 point
Loaders Back Hoes
Replies 29 Post by Art White

Many of the older Kubotas used the same as many of the mowers are today and require an electric PTO clutch. Back then it also required a shaft off the front of the engine to power it unlike the later model. Todays Kubota's use an independent hydraulic wet clutch like their big brothers the farm tractors.

kubota b 7100 belly mower
Kubota Tractors
Replies 5 Post by Art White

Check under the seat for a shut off valve.

F3060 Mower Deck Problem
Kubota Tractors
Replies 3 Post by Art White

Kuhn makes one of the best tillers but they are more then the king Kutter and the likes but in one pass would amaze you. There are a lot of loader manufacturers out there that build a good product.

Wanted to buy
Loaders Back Hoes
Replies 2 Post by Art White

OK.. it was pricey.. but it seems to work very well. 25* this AM.. plugged it in, came back 1/2 hr later and the top coolant hose was warm.

Engine heater
John Deere Tractors
Replies 27 Post by millers1

No, I tried to download it and it is showing up with a filetype of "ram", whatever that is. The downloaded file is only 42 bytes.

Tortured Toyota
Pickup Trucks and Trailers
Replies 7 Post by kwschumm

Greg, Thanks I will go by the local auto store and see what I can find. The picture helped a lot also.

wiring
Jinma Farmpro Agracat Nortrac
Replies 14 Post by mscpilot

Regarding stress and strain on a tractor due to backhoe use.
One thing I learned from seasoned people who own a wide range of excavators is this. One machine will not be the solution to _every_ job. They've taught me to know the limits of any particular piece of equipment.

The operator has to use care and common sense when digging whether it's a B2910 with Wood's BH, or a Caterpillar on tracks!
I use my Kubota for light landscaping and digging. A times I need to dig deep and through woods, and I rent a larger excavator to do the heavy work. Here I use the Kubota for backfill and grading.

This B2910 is ideal in that it's compact to move around a woods lot and get a job done. Plus the fine tuning mechanisms to set the grader at angle, or 'cruise control' turned out to be really useful.

This is the B2910 FEL and Woods 7.5 ' BH that ties to the rear-end with a quick detach system.
I have heard opinions both ways, where the Kubota 3PH mounted Backhoe is worse on the tractor that the unit I own.
My experienced friends taught me how to dig without hurting the machine.

Unfortunately the Good Lord did not dole out equivalent commom sense among owners, so the buyer needs to figure out if the previous owner was careful enough.

IF buying a preowned machine at discount is too risky for you, then the best safe alternative is a brand new Kubota lease deal. albeit more expensive.
I'll write to you off list.
Jeff

value of 2000 kubota B2910HSD Tractor with LA402FL loader
Kubota Tractors
Replies 11 Post by jpostup

I pulled the simplicity into the garage today to have a look and the pin that holds the left part of the axle is broke. I maybe might not have to get rid of it at all i just need a pin because without the pin the whole axle comes out if i just pull on it and when it gets pulled out its not getting any power to that wheel thus its not moving. I know this because i got the axle lined up and pounded it in lightely with the hammer got it off of the stands with the wheels on and drove it back to the shed. I think this should be a fairly easy fix just need a new pin. I guess i will try to fix this again instead of trading it in for a tractor that probably doesnt even run in the first place.

Getting rid of old tractor
Tractor Projects
Replies 9 Post by 77simplicity

CB

You are 100% correct the flatbed trailers are rated in tons and would be far superior to the mobile home system. The Mobile home frame would be eaiser for me to cut and weld if I could get a load rating that would be up to the task. The only thing that I should be driving to the Island is my snapper (lawn mower that is). I have seen the size of some of the individuls that live in these mobile units and the frames may carry more of a load rating than we may be aware of.

bridge for Island
Garden and Landscape
Replies 102 Post by SG8NUC

Why don't they air these on TV. They were all great.

American Automotive Engineering
Just For Fun Off Topic
Replies 3 Post by SG8NUC

Seems like this topic causes a lot of confusion. One of the problems with talking about torque as the measurement of an engine's ability to do work it that torque can be increased or decreased through gearing whereas power cannot. Add a 2:1 dropbox on the engine and torque output will double, but you have not increased the engine's capabilities at all since the speed is halved. Total power available remains the same (minus a little for gear losses, of course).

As another example, take a 540 rpm PTO shaft delivering 25hp. To the implement, it makes no difference what the torque output of the engine is since the PTO shaft is delivering 243 lb-ft (calculated using the hp=(lb-ft)(rpm)/5252 equation). The engine might be a 1500 rpm torquer or a 3000 rpm revver, but torque, and thus power, available at the PTO shaft ends up being the same. For these reasons, engines are always rated by their power output, not torque. Look at the ID tag on an engine and it will list rated power but rarely will say anything about torque because by itself, torque does nothing. Lots of torque at zero rpm does no work at all.

The "torque rise" of an engine is also important in that if torque increases as speed drops, the power output can remain the same. This is where diesels shine as the torque peak is often well below the rated power speed and horsepower does not fall off as the speed drops. And, the diesel's peak power is often at a lower speed than a gasoline engine. Compare pickup engines and you will find that the gas engine's peak power is often at 4500 rpm or more. I don't usually rev my pickup to 4500 rpm so I rarely make full use of the gasoline engine's capabilities. Diesel pickups, on the other hand, make max power at around 3000 rpm. So, at normal engine speeds, the diesel is putting out far more power than the gas engine even if the gasser is rated for more peak power.

Engine RPMs
Kubota Tractors
Replies 9 Post by BrendonN

OK so it was a real Bud light commerical. I found the link.

german tech and arab brains
Just For Fun Off Topic
Replies 17 Post by Peters

Link isn't working. Can you double check it?

Cheers

JDFANATIC

2210 Quick Hitch
John Deere Tractors
Replies 16 Post by JDFANATIC

I have a 2304 and the "other" switch on mine is for the turn signals

E14D Hinomoto dash
Hinomoto
Replies 9 Post by Boxster49rt

We have a brand new B3030 HSDC. The panasonic stereo is very high quality. It's a am/fm/wb/cd with in built outside digital thermostat, the speakers are ok, not great.

Kubota Cab Stereo
Kubota Tractors
Replies 6 Post by lawnking

In the northwest the term is swamping. I worked for a short while swamping in the woods. We swamped some 15 or 20 miles of logging road, with machette once. We also swamped out survey lines for new roads high in the mountains. We had a Stihl extended blade cutter, but it lasted about a day. Now here they run down the rightaway with a machine or spray it. Even thirty years ago the use of herbicides in the Pacific Nortwest was curtailed.

GRUBBING
Tractor Projects
Replies 7 Post by Peters

77

I think that the tractor he is looking for is a 6 cylinder desiel 400ci and has 100 pto hp. But I may be mistaken

looking for tractor to build for pulling
Antique Tractors
Replies 4 Post by SG8NUC

Mice in a 1974 corvette stingray convertable sucks. That happend to me before stupid things. I had to take the dash board appart to get their nest out now he whole inside of the car smells like mouse crap. I put some smellys in there and cracked the window a hair for a few days didnt help. But there isnt much you can do except for put out moth balls mouse traps and maybe get a mouser cat.

Mice
Parts and Repair
Replies 39 Post by 77simplicity