Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Ignition pin out Gator AMT 600

AMT600 Need Key Switch Pinout
Utility Vehicles UTV/ATV
Replies 4 Post by vaughn45

I am not sure what you are talking about. Are you addressing the rolers on the cams? Enclose a picture please.

Clutch Weights
Utility Vehicles UTV/ATV
Replies 4 Post by vaughn45

I used 4 P-48-12 bushings. Specified a 7/16 dia. for the inside bushing bore. These are standard drill bushings fully hardened. I then ordered 4 7/16 inch OD. x 3/8 inch ID. pressure theated bronze bushings. Pressed them into the bushings and bored the ID. to final size. The part number specs out the OD. and Length. You supply the ID. that you want. These are every day standard bushings you can order threw McMaster Carr or any tooling company. Bronze bushings thru your bearing supply house.
As for the gator jumping out of gear, I just finished repairing mine. Sorry to say I had to go to ebay and buy my gears thru them and it was $584.00 if I rember right. I also bought the chain inside along with a new shifting block. The gear for the forward motion and the slider gear were both rounded off. Worked fine as long as you held it in gear, but put a load on it and it didn't like it to much. Three gears and two bearings is what you get. Hope this helps.

Metal rollers for 4x2 JD Gator primary clutch
Utility Vehicles UTV/ATV
Replies 19 Post by vaughn45

I suspect you have a bad head gasket. You might look at the plugs and be able to determine if one cylinder is being sprayed with water. Should have a real clean looking plug.
Just what I would do. I really don't suspect the water pump but it is a possability

Water in oil
Utility Vehicles UTV/ATV
Replies 15 Post by vaughn45

I am in the process of rebuilding a primary clutch off a 2007 or 2008 4x2 gator. Not sure what the internals look like in your clutch. There is a solution for removal in this forum. The only difference was mine was a 17mm thread. There is a tool you can buy but you will probably never receive it. Use the 17mm bolt with 1/2 inch dia. rod 3 and some inches long. If the rollers are flat as mine were I bought drill bushings from CarrLane tooling company. Bronze inserts from a local bearing company. Total cost was approx. 50.00 and some change. Hope this helps.

Clutch Rebuild on a 2004 HPX
Utility Vehicles UTV/ATV
Replies 2 Post by vaughn45

Thank you for the information. I have another question. The second gator which takes the belt you told me about has been jumping out of gear while running down the road. Any ideas as to the problem with it?
thank you
Vaughn45

Year and type of Gators
Utility Vehicles UTV/ATV
Replies 6 Post by vaughn45