Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

[QUOTE=Argonaut;201246] Ha hasounds like a STD sticky situation, that could lead to heated viscosity, in a not so timely manner. ... [/QUOTE]
Been doing this for over 20 years with no problems.

Used Hydraulic Fluid as Chainsaw Bar oil
Shop Tools
Replies 11 Post by tbear640

[QUOTE=Benpinckard;201092] I have a Massey Ferguson 205-4 Diesel Tractor. Since I had it overhauled , it smokes excessively when it is started. For about 2 minutes it puffs whit ... [/QUOTE]
If it has glo plugs pull them and do a compression check. Check both dry and wet. Check fuel filter and fuel vent cap, white smoke indicates unspent fuel while both could indicate timing or internal compression issues.

Massey Ferguson 205-4 starting and power problem
Massey Ferguson Tractors
Replies 20 Post by tbear640

Change your password immediately

Login credentials
Website Operations Howto
Replies 8 Post by tbear640

I have used for many years used hydraulic fluid in my chain saw oiler, I mix STP oil treatment with a gallon of oil then use. Chain saw uses a little more oil but it’s economical to make and use.

MT 372 Mitsubishi How to change Hydraulic Fluid
Mitsubishi
Replies 3 Post by tbear640

Oil seals on my Massey Ferguson right side started leaking about 12 years ago so I disassembled and ended up replacing the oil seals and it still remains dry but this year the left side has started leaking so I just picked up both oil seals for that side. I will definitely not buy bearings until I disassemble it and check it out due to the expense of the bearing, I don’t think the bearing is bad but it’s always a possibility. It’s not a difficult job but due to the size of the parts take your time and work safe.

4x4 front axle leaking fluid
Mitsubishi
Replies 5 Post by tbear640

I�m looking for a wife with a truck, if you know of one send me pictures of the truck.

Wife or truck
Just For Fun Off Topic
Replies 5 Post by tbear640

Are you losing coolant? water has to be coming from somewhere.

Massey Ferguson 1100 vent question
Massey Ferguson Tractors
Replies 5 Post by tbear640

What are the considerations when changing a 2 spool joystick controller on my Massey 1428V. Flow rate and ?, are there other factors when exchanging one controller from another. I have access to other 2 spool controllers.

2 spool loader controller
Massey Ferguson Tractors
Replies 2 Post by tbear640

[QUOTE=armijolj;198224] I need to locate the safety switches for testing but cannotfind a manual that shows the exact locations of the switches and what they look like. In need of adult supervision, thanks. [/QUOTE]
My Massey has 3 safety switches that I can think of, there is a switch located on the bottom of the seat that indicates if you're sitting on the tractor. There is another switch on the high, low, super low shifter that indicates if the tractor is in gear, mine is located under the deck where the gear engagement lever enters the case. Then another switch that indicates if the PTO is engaged but I'm not sure where exactly that is located but you should be able to trace the PTO engagement lever and locate it. If your Massey has a hydrostatic drive then look for the gear engagement switch look around the gear engagement lever.

MF 1260 safety switch locations
Massey Ferguson Tractors
Replies 3 Post by tbear640

The knob that you are referring to is for the the 3 point arm speed for up and down movement.

1985 MF 1020 Knob under seat
Massey Ferguson Tractors
Replies 3 Post by tbear640

You may have a loose connection on your seat switch or switch may be loose and need readjustment.

1435 deck and Enginer cuts out at random
Garden Tractors
Replies 2 Post by tbear640

There must be a seal on your steering box attached on the end of your steering shaft.

Massey Ferguson T035 steering leaking
Massey Ferguson Tractors
Replies 2 Post by tbear640

Does anyone know where I can buy parts for my Massey Ferguson online due to the distances that I live from the dealer.<br>
I'm not looking for cheaper parts but it would be nice to order online and receive parts via UPS or Fed Ex without having to drive and take time off from work to go there.

Massey Ferguson Parts
Massey Ferguson Tractors
Replies 4 Post by tbear640