Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

You may need to check an engin manual for this your engin may have the valves timed or valve timing set befor you can check the gap...paul

B1750 Valve Adjustments
Kubota Tractors
Replies 3 Post by tarbaby

you can't keep small tractors on the lot long enough, they're hot item up here in maine.

Question for BX B owners
Kubota Tractors
Replies 10 Post by tarbaby

water is 8 lb per gallon

Tractor Tire Tire ballast
Kubota Tractors
Replies 35 Post by tarbaby

Ben, the best I found was from tirechains.com

Tire Chains
Parts and Repair
Replies 4 Post by tarbaby

up here in maine the water will freeze

Water in tractor tires
Parts and Repair
Replies 4 Post by tarbaby

Chief, are you sure it was a homer product,you know that after a few eggnogs you can't tell the difference anyway, I think it's full not 100% i think? mabey? if you get to down load the product data spects work sheet, you can ask for this and they will send it to you i think it's www.homer.com back to the eggnog . paul

Synthetic Hydraulic Fluid
Parts and Repair
Replies 83 Post by tarbaby

I hooked my front and back lights on the underside of the rops, hooked into the tail light with seperate fuse and switch, one wire hot along the inside of rops, used thr rops as the ground, works fine,{rops up see the ground} {rops down see the stars} .paul

Wiring Rear Lights
Kubota Tractors
Replies 7 Post by tarbaby

Greg, #2 looks good, at some point you will over cook the glow plugs, I'm not sure what the life of a glow plug is{ on time } you do have good compression,? has the injector pump been removed,? timing off on pump,? wish i could help more, good luck, paul

6284D starting hard any ideas
Cub Cadet
Replies 9 Post by tarbaby

when you want the best you pay more and I'm sold with amsoil in all my vehicles, tractors,and hydro trans also, I have noticed a quite difference in the motor and HST, check out the amsiol.com web site for more info.

Amsoil Oil do you use it
Parts and Repair
Replies 31 Post by tarbaby

If your looking to build a firewood processor, parts are available at the surplus center.com for pumps,hose,motors,exc and northern tool.com for the same.my son makes these units and a lot of time goes into them,a good plan is needed from auto load or manual loading the chain speed along with the chain saw bar to cut the length of wood, 10 H.P. motor is the smallest,you need to have power to run the hydro- motor along wit cutting, and moving the tree length log along,you need a good plan.

Firewood proccesor
Tractor Projects
Replies 12 Post by tarbaby

sounds like a head gasket, oil goes up antifreeze goes down is the rad, blowing steam out of the cap?

Help Blown head gasket
Kubota Tractors
Replies 8 Post by tarbaby