Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Thanks! I have not worked on it for a couple of weeks but have the injectors out,,

Where to have Yanmar Injectors cleanedchecked
Utility Vehicles UTV/ATV
Replies 5 Post by pposey

Dohhh I found them and they actually come with new injectors as well'' JD calls them "Packing" part #M89134

Heat shields for 3tne68 in gator
Utility Vehicles UTV/ATV
Replies 2 Post by pposey

Do you have the lines hooked up correctly? and or the electrical lines hooked correctly? If your electrical wire are switched I believe it could cause this

Trouble shooting no fuel in lines 620I XUV after replacing elc pump
Utility Vehicles UTV/ATV
Replies 2 Post by pposey

[QUOTE=gatoraider;196157] The rod you speak of is only for the gas motors. The diesels have a mount on the driver's side that is supposed to address the forward/rear motion. Adjusting it is detailed in the shop manual, but I don't know how much it helps. Diesel motors shake so bad normally that they can't be tied down solid like the gas motors. [/QUOTE]

OK I found the mount you mentioned but cannot find anywhere how to check belt tightness for adjustment? Can you please point me in the right direction? The mount looks like it could be shimmed to limit motion some.

My main concern is that the belt seems to loose, it is actually rubbing on the outside of the belt against the gator frame on the bottom and is very close to hitting the exhaust manifold on the top. The writing on the outside of the belt is being rubbed off.

2000 6x4 gator Spreader bar between engine and tranny
Utility Vehicles UTV/ATV
Replies 4 Post by pposey