Tractorpoint Login

print < Tractorpoint Login

Tractorpoint

Forums
- Search
- Forums
- New Posts
- Photos
- Manuals/Links
Parts
Support
Account

Search for =

Topic

Thanks for the heads up, it turned out to be pretty straight forward. Just took a little thinking about the proper order so that I could back over it when it comes time to re-connect it.

For reference sake (couldn't find anything when I searched before):

1. Lower the stabilizers so that they are just barely taking some weight.
2. Lower the arm to the ground until is pivots the backhoe slightly towards the tractor (along the stabilizer axis) and and puts some slack on the upper connection link that connects to the tractor just beneath the seat, and remove the pin.
3. Lower the arm on the backhoe a little more until the sub-frame is loose enough that you can remove the pins that secure the sub-frame to the tractor (just under the footrest).
4. With the hydraulic lines still connected, drive forward until the pin on the hoe comes out of the u-joint (for lack of a better term) on the tractor (may need to dig in the bucket or wiggle the arm to cause it to drop out).
5. Disconnect the hydraulic hoses, and drive off fully.
6. Lower the stabilizers so that the main body of the hoe is down on a block or something and lower the arm so that the sub-frame is off the ground.

I'm sure this is too much typing for something that you can just figure out anyway, but thought I'd type it up :)

JD 7 Backhoe removal
Loaders Back Hoes
Replies 4 Post by pitpawten