Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

My 420 loader bucket cutting edge is 3/4" thick. For the width that I need, 59 1/2", all of the toothbars that I see are manufactured for a bucket with a cutting edge no more than 5/8" thick so the toothbar would not fully engage the front of the bucket. Does anybody use one of these on thier loader or is there a toothbar that I have missed out there made for a thicker edge?

JD 420 loader toothbar
Loaders Back Hoes
Replies 2 Post by jpwazz

This happened to me last year, I found that the wires were actually pulled loose from the snap-together coupler. You have to look really closely to find the trouble. After you do find and fix it, make sure you tuck the wires back up and keep them in place with wire-ties or tape. Also, if you can find or make a shield for beneath the platform this will help alot. Good luck on the fix! JP.

John Deere 4210 Reverse Pedal not Working
John Deere Tractors
Replies 10 Post by jpwazz

I FOUND IT!! After an exhautive search I found a wire that had wiggled loose from its connector body underneath the driver platform. I am at a loss as to why it came loose, I certainly wasnt working in conditions to have caused this failure. Perhaps I was not aggressive enough in my initial attempts to identify a loose connection but I also would not have liked to make matters worse by pulling too hard on a sound connection. In any event, thanks to all for you're valuable input on my problem. JP.

4310 no forward gear
John Deere Tractors
Replies 12 Post by jpwazz