Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

If I were you, I would forget the front pump and plumb the valve from the tractors hyd. system.
The YM330 either has a diverter block or outlet and inlet ports.
It's easy to do and you don't loose any power or speed.
Gary J.

Yanmar 330 Loader
Yanmar Tractors
Replies 3 Post by jamtrac2003

I can supply you with a U.S.Yanmar Tractor. Contact me for further info. Thanks.

Yanmar Models to Avoid
Yanmar Tractors
Replies 5 Post by jamtrac2003

I can supply you with a front spindle. Contact me for price.

Front spindle for yanmar 240D
Yanmar Tractors
Replies 4 Post by jamtrac2003

The YRB stands for Yanmar Rear Blade. This blade mounts on the three point hitch in the back. Yanmar did make a YFD240, Yanmar Front Dozer, that fit the 195 and the 240. But that has been discontinued for a long time. Someone out there may have one for sale. Perhaps they took off the dozer blade and put on a front end loader.

YRB-105 Blade Assembly attachment
Yanmar Tractors
Replies 2 Post by jamtrac2003

I just looked in the YM155D Parts Manual, Yanmar made two different gears for 1st/rev. If your s/n is before 51000, then it calls for part no. 194200-25530.

Yanmar YM155D problem w replacement gear from Yanmar
Yanmar Tractors
Replies 9 Post by jamtrac2003

The YM186 was a really well built tractor. Yanmar produced them for four years, from 1980 to 1983. Then replaced it with the YM187, which was basically the same but with taller tires and a 5" longer wheelbase. I sold alot of them and they have held up very good, as have all their other models with the Power Shift Transmission. It was sold as a 18 H.P. and had a three cyl. engine. The hydraulics are very powerful and quite fast. I think you will be glad you bought it. Gary J.

what is a yanmar model 186 w shuttle shift
Yanmar Tractors
Replies 4 Post by jamtrac2003

You didn't say what model tractor you have. It may be something unique to that model. But usually that happens when the pressure relief on the loader is set higher than the pressure relief on the 3 pt. hitch. Gary J.

3 ph not working
Yanmar Tractors
Replies 8 Post by jamtrac2003

DaveA, I have been a Yanmar Dealer for 30 years and have encountered this problem a few times. The top bearing is not sealed and does not get lubricated because it is above the level of the oil. We replace it with a sealed bearing. I can ship you the Service Manual and a sealed bearing (or 2 if you want to change the other side also).
Thanks, Gary J.

Yanmar 226D 4wd Problems
Yanmar Tractors
Replies 17 Post by jamtrac2003