Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Just curious, how much oil roughly should the injector pump hold? When I drain mine I'd like to know how close it was to being full. I am thinking the capacity to be about a cup or so. Is that close?

Also I have looked all over my water pump for a grease fitting but one as yet cannot be found. I heard somewhere that some Y385's were built w/o one though it does show one on the print in my manual......

change oil on fuel pump ty 290 20 hp
Jinma Farmpro Agracat Nortrac
Replies 8 Post by farmpro_newb

OK, Firstly thanks to all the gang here. Greg had good advice and as usual Affordable Tractor, GREAT Service. Got the tach sender unit today. The magnet on it felt stronger than the original. I decided to err on the side of caution this time and screwed the sender till it met the flywheel then backed it out 2 full turns. (Knowing I could always screw it in further should it not work). I wanted to guarantee I had no contact with the flywheel once the tractor was running. Plugged it in started the tractor and the Tach seems to be working like a charm!! Must be a strong magnet huh? Just a very weird coincidence to have my tach sender unit fail at the same time I had replaced the oil pressure gauge, fuel gauge, and starter switch. (All with the positive post of my battery disconnected. The old fuel gauge never registered a reading and with the new one it pegs to full all the time, though sometimes while traveling and the tractor moving around the fuel gauge seemingly will go to the true fuel level but not stay there. I am supposing pulling the fuel sender unit would involve pulling the dash and hood? I just don't feel quite up to doing that alone, again. Seems to me that it is a 2 person job.

But really great results nonetheless thanks to all the help here. Any comments regarding the fuel gauge or my Tach experience would be most welcome! Thanks...... Jim

Farm Pro 2425 Tach
Jinma Farmpro Agracat Nortrac
Replies 6 Post by farmpro_newb

OK!! I took her out in the fields in 4WD and started pulling a tree to my brush pile. While traveling through a mushy spot the rear tires started to spin a bit but I noticed the front tire spin and grab as well. Seems to me it works after all. I guess I just didn't test it correctly or something with the front tires raised. I gotta believe from what I saw the 4WD is fixed. Right? I have a couple more issues but will post it on a new thread. THANKS ALL!!!

Farm Pro 2425 4WD working
Jinma Farmpro Agracat Nortrac
Replies 28 Post by farmpro_newb