Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Murf,
A Curtis loader blade without the curl circuit is just short of useless. When you lift tha loader arms to push off the top of a snowbank the plow would be sticking stright up in the air.

I have neighbors witht he Curtis loader blade and they say if you do it you need the third valve.

regards,
chris

Adapting a Snowplow to Kubota B2910
Snowblowers / Snow Plows
Replies 6 Post by cmhyland

Thanks for the input,

The 2 inches above grade is this....

The building is small 14 X 16 and the sills are all 1 piece.

All the upright posts are good except for 1 corner so I'm not replacing all the posts. Each horizontal sill beam 8x8 needs to be replaced as 1 unit. I think I'll need more room than 1/2 inch to get these into place.

I'm not going to rehang a floor in this building again. It's on a small slope and I'll fill it with 1/2 inch stone and pour a slap inside. I'll be using pressure treated for the sills.

I do plan to put concrete footings under each beam and restack the plinth stones under the rest of the sill.

Regards,
Chris

Replacing Post and Beam sills
Barns Pole Barns
Replies 7 Post by cmhyland