Position Control question
BARNEE
Join Date: Nov 2003 Posts: 64 South Texas Pics |
2003-12-28 72489
I have an L3000DT with position control. I seem to get good control over movement of the 3ph in the downward direction (i can lower it incrementaly with incremental position lever movements), but not as good in the up direction. Once the 3ph has been lowered to a certain position I have to move the position lever quite a ways in the opposite direction before it starts to raise. it's basically a trial & error process to find the point the implement will start to raise again. Makes it difficult to control for box blade work. Is this pretty much normal? My B7100D had finer control although it had a slightly different system.
thanx
Reply to | Quote Reply | Add Photo
Go Top
Share This