![Go Bottom](http://tractorpoint.com/images/pageDown_sml.png)
Compare loaders
![]() | DanaT
Join Date: Jun 1999 Posts: 138 Clay Center,Ks ![]() |
2000-11-29 21948
Iam trying to compare a JD 4300 & a TCNH35D. The 3 point lifts are very close, the loader lift & break out cap on the NH are at bucket pivot point & at end of the bucket. Does anyone know were JD spec's come from, are they at the same points? NH has a much better interest rate so I should consider them to. Thanks for any info.
Reply to |
![Quote Post Reply to Post](https://tractorpoint.com/ctb/images/reply.gif)
![Add Photo](https://tractorpoint.com/ctb/images/photoS.gif)
Compare loaders
![]() | Bernie Galgoci
Join Date: Posts: 1 ![]() |
2000-12-04 22116
Dana: I don’t know about the JD 420 loader, but - taken from the loader manual - the JD 430 loader specifications on the 4300 tractor are: Breakout Force at Pivot Pin = 3299 lbf (14676N), Breakout Force 500mm Forward of Pivot Pin = 2417 lbf (10752N). I include the metric equivalents in case you are more familar with that system. Hope this helps with the decision. ....
Reply to |
![Quote Post Reply to Post](https://tractorpoint.com/ctb/images/reply.gif)
![Add Photo](https://tractorpoint.com/ctb/images/photoS.gif)
Compare loaders
![]() | DanaT
Join Date: Jun 1999 Posts: 138 Clay Center,Ks ![]() |
2000-12-04 22122
Thanks Bernie, I wanted to make sure I was compareing apples to apples. Now it's time for pondering. ....
Reply to |
![Quote Post Reply to Post](https://tractorpoint.com/ctb/images/reply.gif)
![Add Photo](https://tractorpoint.com/ctb/images/photoS.gif)
![Go Top](http://tractorpoint.com/images/pageUp_sml.png)
![Share This](http://tractorpoint.com/images/share_this_sml.png)
Share This