Where to get hydraulic toplink for TC29D
Danny Yerks
Join Date: Posts: 1 |
2002-04-30 37976
Does anybody know of a source of ready made hydraulic toplinks? My existing toplink is about 18” from hole to hole when fully retracted and about 27” when fully extended. This for adding top and tilt. I have the rear remote hydraulics installed.
Reply to | Quote Reply | Add Photo
Where to get hydraulic toplink for TC29D
TomG
Join Date: Feb 2002 Posts: 5406 Upper Ottawa Valley |
2002-05-01 37995
I'd probably just ask my dealer. My top link came as part of my 3ph forklift, so I don't know specifics about the cylinder except that the loops are for CAT II pins and I have sleeves to size them to my CAT I pins. My dealer did put extra long hoses on the cylinder so I can run the top link from the loader curl valve when I use my rear outlet for the forklift cylinder. ....
Reply to | Quote Reply | Add Photo
Where to get hydraulic toplink for TC29D
John Mc
Join Date: Feb 2002 Posts: 98 Vermont |
2002-05-01 38029
Tisco makes one that extends from 20" to 28". I have it on my TC33D. It was the closest fit (their next size smaler was too short, and also had too short a range of motion). After trying it out, I ended up shortening it by a couple of inches by cutting off most of a spacer that is welded to the fixed end of the cylinder. Unfortunately, I do not have the part number, but I got it from my NH dealer. If you can't find one, let me know and I'll try to get the part number for you.
Gearmore also makes good cylinders (some say better quality than Tisco). Worth looking at as well.
John Mc ....
Reply to | Quote Reply | Add Photo
Go Top
Share This