Go BottomSteiner 430 max PTO belt installation how to
 | treecareco
Join Date: Oct 2014 Posts: 2 connecticut 
|
2014-10-25 191281
Hello . I have a steiner 430 max with the Kubota d-722 and my pto belt (engine to double idler pulley) broke . I bought a new one at napa correct size and im having awful time with it. I cant get the pto lever to stay engauged , im having the rod that's got the two equalizing springs coming into contact with the single idler so ive adjusted that but somethings not right and I cant figure it out all day into the night now. What could be wrong?
Reply to |
Quote Reply |
Add PhotoSteiner 430 max PTO belt installation how to
 | minimac
Join Date: Jun 2013 Posts: 104
 Pics
|
2014-10-26 191285
It is necessary to check the PTO belt adjustment
A. Each time a new attachment is installed.
B. If the PTO drive belt slips or does not release
properly.
1. Attach the new implement using the correct
attachment drive belt. See the Attachment
Operator’s Manual for the correct belt or the belt
chart on page 5-10 in this manual.
2. Stop the engine, engage the PTO lever and check
the distance as shown in above drawing. The
correct distance between the PTO drive belt is
2-1/4 to 2-1/2 inches (1-1/2 to 1-3/4 for Kubota). If
the distance is less than 2-1/4 inches (1-1/2
Kubota) the drive belt may slip. If the distance is
greater than 2-1/2 inches (1-3/4 Kubota) the drive
belt may not release properly when the
attachment is raised to the highest position.
3. Disengage the PTO and adjust the idler slide
assembly by turning the belt release catch handle
clockwise to tighten belt and counter clockwise to
loosen belt. Adjust to obtain the correct
measurement as stated in step 2.
NOTE: If correct measurement is not possible,
check for an improper size drive belt.
4. Start the unit and raise the attachment to full height.
The attachment should not run with PTO
disengaged. If it does, the drive belt adjustment is
too tight. Repeat Steps 1 through 4.
STOP EN ....
Reply to |
Quote Reply |
Add PhotoSteiner 430 max PTO belt installation how to
| minimac
Join Date: Jun 2013 Posts: 104
Pics
|
2014-10-26 191286
Steiner PTO Pulley diagram ....
Picture Link
Reply to |
Quote Reply |
Add PhotoSteiner 430 max PTO belt installation how to
| lawnboy1955
Join Date: Apr 2018 Posts: 2 Grayson, Ky
|
2018-04-23 197703
Where does the spring for the idler pulley hook on the tractor side, I know where it goes on the pulley but not where it attaches to the tractor. ....
Reply to |
Quote Reply |
Add Photo
Go Top
Share This