3 pt hitch problem
jtlittle47
Join Date: Jun 2009 Posts: 3 Winston salem, NC |
2009-06-03 163151
My MTE2000D: Just had new hydraulic pump installed and now the loader works fine but the 3 point hitch quit working. It was intermint. for a while but now will not raise the box scrape. It will slowlyraise the arms when I remove the scrape but any force leaks back down. I have checked linkage but seems to be OK. Where do I go from here I can't find a repair manual but I have a Parts manual. It worked fine for about three hour, then it went down and can not raise. HELP if you can.
Reply to | Quote Reply | Add Photo
3 pt hitch problem
hardwood
Join Date: Dec 2002 Posts: 3583 iowa |
2009-06-03 163153
Being it work properly after the new pump was installed and now everything else works except the three point I would suggest checking the linkage from the three point control lever to the three point valve. Perhaps the lever isn't moving the valve to it's maximum stroke needed for full function. ....
Reply to | Quote Reply | Add Photo
3 pt hitch problem
auerbach
Join Date: Sep 2007 Posts: 2168 West of Toronto Pics |
2009-06-03 163154
I'd start with the simple things, though I don't know what brand that is (Mitsubishi?).
Is there not a hitch control or two that might have been moved during the pump work? If so, it should show on the parts breakdown, likely in the seat area. Are the linkages from the control intact and free-moving?
Is the fluid the right kind and amount, and are its filters OK?
I think the next step would have to be to remove the hitch body and check for stuck valves or leaky O-rings.
Meanwhile, try removing the rear attachment and the arms (if you can't raise them) so you can use the tractor for other things. Good luck. ....
Reply to | Quote Reply | Add Photo
3 pt hitch problem
jtlittle47
Join Date: Jun 2009 Posts: 3 Winston salem, NC |
2009-06-03 163157
fluid is OK, New 21/2 gallons, Everything seems to be working right. It is a mitsubishi. I'm not sure where the control valve is for the 3 point hitch.I can follow most of the lines but it goes through the rear housing and can't see where it goes from there. Parts breakdown is not too clear. A local tractor company changed the pump and oil so I would say they are the correct type.
Thanks, ....
Reply to | Quote Reply | Add Photo
3 pt hitch problem
popebl
Join Date: Feb 2010 Posts: 9 north carolina |
2010-02-17 168695
IT sounds like the uploader valve is stuck open. It may have some dirt or metal fillings in the seat. remove and clean the valve. ....
Reply to | Quote Reply | Add Photo
Go Top
Share This