Tractorpoint Login

print < Tractorpoint Login

Tractorpoint

Forums
- Search
- Forums
- New Posts
- Photos
- Manuals/Links
Parts
Support
Account

Search for = topjimmy

Topic

I've looked at the manual and parts book and it seems that there is no screen...as for the pickup tube the inlet line starts at the bottom of the transmission below rear axle and elbows up about an inch or so where it enters the filter housing the continues to run along the bottom of the transmission to just in front of the floor boards where it makes a 90 degree turn upwards. It rises approx. 6 - 8 inches, this is where it goes above the level in the reservoir (its a common reservoir for transmission and hydralics). After it rises it turns 90 degrees again and runs along side the engine to the inlet of the pump. I have tried adding to the inlet side but it just uns back to the filter and reservoir. I think my next step is to drain it again and take all of that run of pipe off and make sure there is no blockages but I was hoping I would have to do that.

Thanks for the reply!

Hydraulic problems
Massey Ferguson Tractors
Replies 4 Post by topjimmy