Tractorpoint Login

print < Tractorpoint Login

Search for = tinker

Topic

my 3point on my 2260 long trys to lift dose not get far then will not lift at all. have drained oil and cleened strainer and some valves. have not refilled yet . do not no if i need to pull plug under tractor rearend to . or is it filled sepert. the 3 point has ben slow sense i got the tractor a few years ago.this is my first total drain of hydro.

2260 long 3 point dose not work
Long
Replies 4 Post by tinker

Changed oil in the long today.And i cleaned and lubed the hydraulics levers and linkage.Works much better'Think i will drain all the hydr out and put in new that may make it even better.And there is only a suction screen filter.Think i will try to get a operater manual for the tractor so can get the right fluids.

long hydrauliics
Long
Replies 4 Post by tinker

Thanks checked it out. Gave me an ideal where to start .Not an easy job.

Long 2260 Tractor How to Install New Brakes
Long
Replies 3 Post by tinker

I just purchased a Ford tractor/loader/backhoe and I'm trying to determine exactly what it is, in order to get applicable operating and maintenance/repair manuals. I believe it to be a 1968 industrial series tractor. The under hood ID label is intact, and it reads as follows:<br>
<br>
model# 45021G (4,000 series, industrial, gas engine, no PTO, 4 speed manual trans.)<br>
<br>
unit# 8B26B (1968, Feb. 26, dayshift)<br>
<br>
tractor# C196502 (made in US, XXXXXX)<br>
<br>
In the parentheses are what I think is the correct information. Can anyone confirm my translation of the info?<br>
<br>
This machine has a Wain-Roy backhoe, which according to what I've read, seems out of place on a 1968 tractor. <br>
<br>
Would this be considered a 4400, 4500, 445, 455 or other? <br>
<br>
My immediate concerns are about lubrication for both the lift equipment and the transmission and differential. What I've seen so far is that anything compatible with M2C41, superseded by NH134D is correct for all. True?<br>
<br>
The differential does not have a dipstick. I see some 1/4" pipe thread plugs and what appears to be a machine thread with gasket plug on the left side. I assume that one of these are how I would check the level. <br>
<br>
How full should the lift reservoir, (located top forward under the hood), have to be? I presume that it should be checked with all the hydraulic cylinders as fully retracted as possible?

1968 Ford industrial tractor loader backhoe
Antique Tractors
Replies 2 Post by tinker8La

Thanks for your e-mail. After posting message and much back and forth with Japan I got a parts manual. It's in Japanese. I need stuff like: rod, rod cap and rod bearings.
It is really hard for me to imagine this 3 cyl. diesel engine isn't used on more tractors than the N329.
Does Hinomoto part numbers work for you ?

Hinomoto N 329
Hinomoto
Replies 4 Post by stinker

In high range it makes an aweful noise when it first starts...it sounds very strained....low range is the only gear that gives no problems reagrdless of the load or terrain or implement attached

L3010 HST tranny problems
Kubota Tractors
Replies 12 Post by tinkerp