Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

Try NCW tractor parts they have been helpful when I need parts They have a website #is 8665821172 or 7026551179.
they are in Nevada.
You also might try bruce1966us on ebay He has been helpful also[he found me a low hour complete engine for less than I could of rebuilt it]

Satoh bull S630D Engine Rebuild Kit
Mitsubishi
Replies 3 Post by tnttom

I've changed oil on these things many times.I hate the mess it makes,no matter how careful you are.
One caution is get the specific oil filter wrench that fits housing.[amazon] Housing is plastic,breaks easily. I used my large channel locks first time,I was not comfortible doing it though. I heard housing costs $75.00 or more.So be careful.
I also heard local Toyota dealer likes jiffy lube,they break them a lot.

New Toyota No Oil Filter Cartridge
Autos SUV Trucks
Replies 5 Post by tnttom

did you try a new fuse? the fuse most likely,looks good? But at times I have found sometimes the fuse doesn't make contact at the terminals[corrosion].I have encountered this on my JD 430.

John Deere 4400
Garden Tractors
Replies 5 Post by tnttom

One way to check for a short and save fuses,put/hookup a lite bulb/test lite,where the fuse is,as long as the bulb is lit,there is a short.You can trace the wires,or unhook one wire at a time and narrow it down. tnttom

Blown Fuses
Garden Tractors
Replies 6 Post by tnttom

Heres my 2 cents,I'm not an expert but if you use a larger hole than nessacary,pour in the concrete. [you could also install rebar pins,short ones, while concrete is wet] Let it dry, and when you install poles drill holes in them and,put gravel in the bottom say 6 inches.than backfill with the fill dirt.Gravel will give any water a place to go to,rather than the poles.

Newbie with a pole barn concern
Barns Pole Barns
Replies 8 Post by tnttom

I often see the guys that install them around here [WV] use 3 treated 2x6s in the ground,they leave the middle one 2' shorter and then use framing for the rest of the way.they are staggered to tie them together stronger,and they hinge the top sections up into place. That way they get any length they need and don't pay for higher priced 6x6s.

Pole Barn Advice
Barns Pole Barns
Replies 6 Post by tnttom

My 254 has an Agpro loader, no P.S. I really do not notice a steering issue. It is hooked to tractors hydraulic system,it all works great.

Cae IH 254 3 cyl diesel 4 wd tractor
Case
Replies 9 Post by tnttom