Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

I like the diverter setup except it has a couple of important nuances. When switching between top n tilt rear and 4in 1 front... it will switch most but not all valves... so parts of front and back exercise when using the joystick. I had the dealer replace all the seals initially and this greatly reduced in frequency but has never been eliminated.

Second... you cannot switch when you have a load (e.g. the front bucket). If you do you will have to run the bucket up onto something to eliminate the load (and backpressure on the valves) before it switches.

I'm a bit surprised that this is as buggy as it is. I was also pretty unhappy with the original installation of the topntilt valves by a JD Dealer on my 4610... since the center hydraulic would crash into the valves and eventually severed a hydraulic line... and they dangled a front hydraulic line in air near the right rear axle.

Top N Tilt vs 4in1 Loader Control
John Deere Tractors
Replies 10 Post by sruhnau

I ordered a Gearmore 4in1 heavy duty bucket w/ my JD 4610 and they installed a Bradco heavy duty skid steer loader bucket. Any opinions on which is better and cost diff's?<br>
Thanks, Steve

Bradco vs Gearmore 4in1 Bucket
John Deere Tractors
Replies 1 Post by sruhnau

I ordered a Gearmore 4in1 heavy duty bucket w/ my JD 4610 and they installed a Bradco heavy duty skid steer loader bucket. Any opinions on which is better and cost diff's?<br>
Thanks, Steve

Bradco vs Gearmore 4in1 Bucket
Operating and Attachments
Replies 1 Post by sruhnau