Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

What engine? IF it's the two pot S126, yes I did replace it.

Water pump replacement is not a bad job. Drain the cooling system. Remove all the hoses. Remove water pump. Scrape off old gasket materiel from the block.

I like to use black RTV. Smear some on the block where the WP gasket goes. smear some on the WP. Do use the gasket also as some gaskets also act as a spacer.

Installation steps are opposite of removal.

IF you do use the RTV, allow it to cure before filling the radiator and engine with coolant and water.

Anyone replaced the water pump on a 2304
Hinomoto
Replies 3 Post by rrgrassi

UPDATE: ALL FIXED

I found a local supplier and was able to get a Mitsubishi exact fit alternator.

It does have to have a functioning idiot light to "turn on" the alternator.

Now charging at 14.2 volts.

Hinomoto E230 Alternator Wiring issue
Hinomoto
Replies 2 Post by rrgrassi

Order a manual. I am using the repair manual for an Allis Chalmers 5020.

Your fill point is a big rubber plug just below and in front of the seat. The oil level plug is the bolt to the left of the PTO selector. Tractor Supply has a two gallon jug that meets the AC 821 oil specs.

Trying to find Hinomoto E230 parts is a pain, but when I look for AC 5020 parts, a lot more options come up.

need help with hinomoto e230 3-point hitch
Hinomoto
Replies 4 Post by rrgrassi